Hongshuai Huang

Dr. Hongshuai Huang

orcid

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 March 2025 in Sensors
Verified
Journal Article
Open access
PDF file
WYWenfeng Yang
Wenfeng Yang
XYXinguang Yin
Xinguang Yin
LSLi Shaolong
Li Shaolong
SLShuaicai Liu
Shuaicai Liu
ZRZhang Ran
Zhang Ran
HHHongshuai Huang
Hongshuai Huang
Monitoring the curing process is crucial for guiding and optimizing the curing procedures of composite material repair patches. Traditional embedded online monitoring methods are limited in their ability to track the curing process of these patches. This paper presents a composite material curing monitoring platform designed using dielectric methods. It integrates temperature control, pressure control, dielectric signal acquisition, control and display modules, and is specifically tailored for bag molding curing of repair patches. The platform measures the ionic viscosity of T300 2019B composites, analyzes the curing index, and correlates it with DSC-cured degree tests. The results indicate that the multiple ionic viscosity curves obtained from monitoring exhibit consistent trends, with correlation coefficients between curves exceeding 0.96. The changes in curing index align with the changes in curing degree, demonstrating that the platform can reliably and accurately monitor the ionic viscosity of repair patches. This platform enables effective monitoring of the ionic viscosity during the curing process of composite material repair patches.

29 April 2026 in Materials
Verified
Journal Article
Open access
PDF file
HHHongshuai Huang
Hongshuai Huang
BYBowen Yang
Bowen Yang
YCYu Cao
Yu Cao
ZTZhongxian Tan
Zhongxian Tan
JLJunchao Li
Junchao Li
WYWenfeng Yang
Wenfeng Yang
Carbon fiber-reinforced polymer (CFRP) laminates are susceptible to barely visible impact damage (BVID) under low-energy bird-strike-like conditions. However, in previous studies, most damage evaluations for BVID were limited to a single scale. In this work, a multiscale characterization and evaluation method integrating the analytic hierarchy process (AHP) and the CRITIC weighting method was proposed to investigate the damage evolution of CFRP laminates under low-energy impacts (approximately 12–33 J). Delamination area (SDa), indentation depth (PD), surface crack aspect ratio (RA), energy dissipation, and compression-after-impact (CAI) strength were analyzed based on phased-array ultrasonic C-scanning, 3D optical profilometry, and scanning electron microscopy. The results showed that PD, SDa, and energy dissipation increased from 108.73 μm to 213.93 μm, from 228.6 mm2 to 695.8 mm2, and from 5.96 J to 21.40 J, respectively, with increasing impact energy. Meanwhile, CAI strength decreased from 202.2 MPa to 118.9 MPa, with a maximum degradation rate of 41.16%. A critical transition was observed in the medium-to-high energy range, where delamination growth gradually plateaued, while intralaminar cracking and fiber fracture became increasingly dominant. The proposed framework enables quantitative grading of BVID severity and provides a practical basis for assessing residual damage in impacted CFRP laminates.