The mass adoption of electric vehicles is hindered by the inadequate extreme fast charging (XFC) performance (i.e., less than 15 min charging time to reach 80% state of charge) of commercial high-specific-energy (i.e., >200 Wh/kg) lithium-ion batteries (LIBs). Here, to enable the XFC of commercial LIBs, we propose the regulation of the battery’s self-generated heat via active thermal switching. We demonstrate that retaining the heat during XFC with the switch OFF boosts the cell’s kinetics while dissipating the heat after XFC with the switch ON reduces detrimental reactions in the battery. Without modifying cell materials or structures, the proposed XFC approach enables reliable battery operation by applying <15 min of charge and 1 h of discharge. These results are almost identical regarding operativity for the same battery type tested applying a 1 h of charge and 1 h of discharge, thus, meeting the XFC targets set by the United States Department of Energy. Finally, we also demonstrate the feasibility of integrating the XFC approach in a commercial battery thermal management system.
An all‐iron redox flow battery is proposed and developed for end users without access to an electricity grid. The concept is a low‐cost battery which the user assembles, discharges, and then disposes of the active materials. The design goals are: (1) minimize upfront cost, (2) maximize discharge energy, and (3) utilize non‐toxic and environmentally benign materials. These are different goals than typically considered for electrochemical battery technology, which provides the opportunity for a novel solution. The selected materials are: low‐carbon‐steel negative electrode, paper separator, porous‐carbon‐paper positive electrode, and electrolyte solution containing 0.5 mFe2(SO4)3active material and 1.2 mNaCl supporting electrolyte. With these materials, an average power density around 20 mW cm−2and a maximum energy density of 11.5 Wh L−1are achieved. A simple cost model indicates the consumable materials cost US$6.45 per kWh−1, or only US$0.034 per mobile phone charge.
Symmetric‐structure metal‐supported solid oxide fuel cells (MS‐SOFCs) are fabricated by infiltrating catalysts on both anode and cathode side. Various aspects of the infiltration process are optimized. Performance is found to be sensitive to precursor dilution, catalyst loading, and catalyst calcining temperature. For an optimized cell with lanthanum strontium manganite (LSM) as cathode and Sm0.2Ce0.8O2−δ mixed with Ni (SDCN) as anode, peak power densities of 0.44, 1.1, and 1.9 W cm−2 are achieved at 600, 700, and 800 °C, respectively. A fully symmetric MS‐SOFC with SDCN as both the anode and cathode sides achieves moderate peak power densities of 0.12, 0.37, and 0.76 W cm−2 at 600, 700, and 800 °C, respectively. A solvent‐based infiltration technique is also explored and found to be more effective than capillary forces alone but not as effective as vacuum infiltration.