The lives of many people around the world are impaired and shortened mostly by cardiovascular diseases (CVD). Despite the fact that medical interventions and surgical heart transplants may improve the lives of patients suffering from cardiovascular disease, the cost of treatments and securing a perfect donor are aspects that compel patients to consider cheaper and less invasive therapies. The use of synthetic biomaterials such as titanium-based implants are an alternative for cardiac repair and regeneration. In this work, an in situ development of Ti-Al-xNb alloys were synthesized via laser additive manufacturing for biomedical application. The effect of Nb composition on Ti-Al was investigated. The microstructural evolution was characterized using a scanning electron microscope (SEM) equipped with energy dispersive spectroscopy (EDS). A potentiodynamic polarization technique was utilized to investigate the corrosion behavior of TiAl-Nb in 3.5% NaCl. The microhardness and corrosion behaviour of the synthesized Ti-Al-Nb alloys were found to be dependent on laser-processing parameters. The microhardness performance of the samples increased with an increase in the Nb feed rate to the Ti-Al alloy system. Maximum microhardness of 699.8 HVN was evident at 0.061 g/min while at 0.041 g/min the microhardness was 515.8 HVN at Nb gas carrier of 1L/min, respectively.
1 June 2022 in International Journal of Lightweight Materials and Manufacture
This work aim to investigate the effect of sintering temperature on microhardness and tribological properties of novel equi-atomic TiAlMoSiW HEA fabricated via spark plasma sintering. The influence of Spark plasma sintering temperature on morphological evolution and phase formation was also investigated. The microstructure and the phases formed for the developed HEA were examined using scanning electron microscopy (SEM) and X-ray diffractometry (XRD) respectively. The microhardness and tribological properties were studied using a diamond base microhardness tester Rtec tribometer. It was noticed that sintering temperature has an effect on microhardness and tribological properties. Phase analysis of the samples displayed that the alloy exhibited a bcc matrix with secondary phase precipitate of ordered fcc TiSi2 phase. The developed HEA showed improved mechanical properties as the sintering temperature increases.
15 August 2019 in The International Journal of Advanced Manufacturing Technology
This work aims to evaluate the effect of chromium (Cr) as a dopant on microstructural evolution, microhardness, electrochemical behavior and tribological properties of ternary Ti-Al-xCr alloys synthesized via laser in situ alloying technology produced from their elemental powders. Computational thermal analyses of 3D printed Ti-48Al and Ti-Al-4Cr alloys were modeled and simulated by means of COMSOL Multiphysics. This was compared to the laser processing parameters to understand the thermal behavior of the alloys during manufacturing. The ternary Ti-Al-xCr alloys were synthesized at a scan speed of 10.58 mm/s and laser power of 450 W. The effects of Cr powder feed rate on Ti-Al matrix were studied at a gas carrier of 1 and 2 L/min, respectively. The microstructural evolution of Ti-Al-xCr alloys was examined using scanning electron microscopy equipped with energy-dispersive spectroscopy. The corrosion and oxidation behavior of the in situ alloyed Ti-Al-xCr were studied using potentiodynamic and thermal gravimetric techniques, respectively. Normalizing heat treatment on microhardness was performed at the temperature of 1350 °C. The findings showed that there was significant decrease in microhardness properties after HT. The computational model demonstrated minimal thermal distribution change proving that minimal or crack free alloys were developed. The results also showed that Cr addition to Ti-Al matrix resulted in improved tribological properties and oxidation behavior of the alloy.
About Me
Mr. Rudolf Kanyane, Doctoral Student at the Tshwane University of Technology.
Mr. Rudolf Kanyane, Doctoral Student at the Tshwane University of Technology.