Aofei Tang

Dr. Aofei Tang


Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 October 2016 in Journal of Manufacturing Science and Engineering
Verified
Journal Article
Closed access
PDF file
SLShujuan Li
Shujuan Li
ATAofei Tang
Aofei Tang
YLYong Liu
Yong Liu
JWJiabin Wang
Jiabin Wang
DCDan Cui
Dan Cui
RLRobert G. Landers
Robert G. Landers
Free abrasive diamond wire saw machining is often used to cut hard and brittle materials, especially for wafers in the semiconductor and optoelectronics industries. Wire saws, both free and fixed abrasive, have excellent flexibility, as compared to inner circular saws, outer saws, and ribbon saws, as they produce a narrower kerf, lower cutting forces, and less material waste. However, fixed abrasive wire saw machining is being considered more and more due to its potential for increased productivity and the fact that it is more environmentally friendly as it does not use special coolants that must be carefully disposed. The cutting forces generated during the wire saw process strongly affect the quality of the produced parts. However, the relationship between these forces and the process parameters has only been explored qualitatively. Based on analyzing the forces generated from the chip formation and friction of a single abrasive, this study derives an analytical cutting force model for the wire saw machining process. The analytical model explains qualitative observations seen in the literature describing the relationship between the cutting forces and the wafer feed rate, wire velocity, and contact length between the wire and wafer. Extensive experimental work is conducted to validate the analytical force model. Silicon carbide (SiC) monocrystal, which is employed extensively in the fields of microelectronics and optoelectronics and is known to be particularly challenging to process due to its extremely high hardness and brittleness, is used as the material in these experimental studies. The results show that the analytical force model can predict the cutting forces when wire saw machining SiC monocrystal wafers with average errors between the experimental and predicted normal and tangential forces of 9.98% and 12.1%, respectively.

23 November 2015 in MATEC Web of Conferences
Verified
Journal Article
Open access
PDF file
ATAofei Tang
Aofei Tang
SLShujuan Li
Shujuan Li
YWYunfei Wu
Yunfei Wu
XFXiaohua Fang
Xiaohua Fang
The dynamic model of the 6 DOF Wire Driven Parallel Mechanism (WDPM) system is introduced. Based on MATLAB system, the simulation of the inverse dynamic model is achieved. According to the simulation result, the mechanical model for the WDPM system is reasonable. Using ADAMS system, the dynamic model of the virtual prototype is verified by the simulation analysis. The combined control model based on ADAMS/Simulink is derived. The WDPM control system is designed with MATLAB/Simulink. The torque control method is selected for the outer ring and the PD control method for the inner ring. Combined with the ADAMS control model and control law design, the interactive simulation analysis of the WDPM system is completed. According to the simulation results of the spatial circle tracking and line tracking at the end of the moving platform, the tracking error can be reduced by the designed control algorithm. The minimum tracking error is 0.2 mm to 0.3 mm. Therefore, the theoretical foundation for designing hardware systems of the WDPM control system is established.

15 February 2025 in Iranian Journal of Science and Technology, Transactions of Mechanical Engineering
Verified
Journal Article
Closed access
PDF file
GYGuigeng Yang
Guigeng Yang
ZGZechen Gong
Zechen Gong
ATAofei Tang
Aofei Tang
BZBin Zhang
Bin Zhang
TNTian Nan
Tian Nan