A homologous series of hyperbranched polyesters (HBPEs) was successfully synthesized via an esterification reaction of 2,2-bis(methylol)propionic acid (bis-MPA) with pentaerythritol. The molecular weights of the HBPEs were 2160, 2660, 4150 and 5840 g/mol, respectively. These HBPEs were used as additives to prepare polysulfone (PSf) hollow fiber membranes via non-solvent induced phase separation. The characteristic behaviors of the casting solution were investigated, as well as the morphologies, hydrophilicity and mechanical properties of the PSf membranes. The results showed that the initial viscosities of the casting solutions were increased, and the shear-thinning phenomenon became increasingly obvious. The demixing rate first increased and then decreased when increasing the HBPE molecular weight, and the turning point was 2660 g/mol. The PSf hollow fiber membranes with different molecular weights of HBPEs had a co-existing morphology of double finger-like and sponge-like structures. The starting pure water contact angle decreased obviously, and the mechanical properties improved.
1 January 2013 in Separation Science and Technology
A novel composite nanofiltration (NF) membrane was prepared by interfacial polymerization of 2,2′-bis(1-hydroxyl-1-trifluoromethyl-2,2,2-trifluoroethyl)-4,4′-methylenedianiline (BHTTM) and trimesoyl chloride (TMC) on polyethersulfone (PES) supporting membrane. Different preparation conditions and NF membrane performances were discussed. The membrane structures of composite NF membranes were characterized by attenuated total reflectance infrared (ATR-IR), scanning electron microscope (SEM), and atomic force microscopy (AFM). The results showed that the NF membrane prepared under the optimum condition exhibited Na2SO4 rejection of 85.3% and the water flux of 10.1 l.m−2.h−1. The NF membrane was treated by 5000 ppm chlorine solution for 1 h. The salt rejection and water flux of the treated membrane reached to 94.5% and 94.8 l.m−2.h−1. The rejection of two NF membranes for inorganic electrolyte solutions decreased in the order of Na2SO4, MgSO4, MgCl2, and NaCl, which were typical characteristics of negatively charged membranes.