Unlike voltage-source inverters (VSI), the power decoupling element in current-source inverters (CSI) is inductor. Inductor has a long lifetime and makes the CSI more reliable. However, the traditional CSIs suffer from open-circuit problem and dangerous voltage spikes are generated if the input inductor current is intermitted. Therefore, to avoid the voltage spikes, overlap-time should be inserted in the gate signals. But these intervals distort the output currents and reduce the current source utilization. To address these issues, a novel three-phase CSI is proposed in this article. The proposed inverter is originated from the conventional seven-switch CSI named CSI7 by adding only two small film capacitors. The film capacitors along with the pre-existing diodes of the CSI7 ensure that there is always a path for the inductor current, and thus the open-circuit issue is resolved. The elimination of open-circuit issue enhances the reliability and allows to minimize the overlap-time. This will improve the quality of output currents as well. Moreover, simulation and experimental results are provided at the output power of 950 W to verify the effectiveness of the proposed inverter.
11 June 2018 in IEEE Journal of Emerging and Selected Topics in Power Electronics
This paper introduces an automatic current-balancing multi-channel light emitting diode (LED) driver. The proposed topology is simple in structure, low-cost, and can achieve automatic current-balancing for multi-string LED applications. Owing to the charge balance condition of the capacitor, the LED channel currents are automatically equalized without requiring any dedicated control or extra circuitry. Thus, there is only one current-controlled circuit necessary to adjust all LED channel currents. The operating principle and phase-shifted pulse width modulation (PWM) control of the proposed two-channel LED driver are analyzed in detail. The extension to multichannel applications is also discussed. A 25-W hardware prototype was built and tested; the experimental results are provided for validation.
24 November 2020 in IEEE Transactions on Power Electronics
In this paper, a novel high-reliability single-phase dual-output current source inverter is presented. By using the switching-cell (SC) structure in the proposed topology, the overlap-time between switching transition can be minimized or eliminated. This improves the quality of AC output currents, efficiency, and dc-source utilization. Additionally, the capacitors in SC structure can help to reduce dv/dt of power switches and clamp the over-shoot voltage under open-circuit problems, thus improving reliability. Two modes of common and different frequency operations are considered and detailed pulse with modulation schemes are presented. A 650 W hardware prototype was built and tested to verify the performance of the proposed inverter, and the results are compared with conventional single-phase dual-output current source inverters.
11 November 2020 in IEEE Transactions on Industrial Electronics
Conventional current source inverter (CSI) suffers from open-circuit problem during switch transition. Thus, overlap-time should be inserted in the gate signals for safe commutation. The overlap-time distorts output current waveforms and increases total harmonic distortion of output current. Moreover, it reduces the current source utilization of the inverter. To solve these problems, this paper proposes a new three-phase four-leg switching-cell (SC) CSI, abbreviated as H8-SC-CSI. With the help of the SC structure, the reliability of the proposed inverter is greatly enhanced as open-circuit concerns are eliminated. In addition, with the intrinsic voltage clamping action of the SC structure, switch voltage overshoot at turn-off is mitigated. In the proposed CSI, the switch overlap-time can be minimized or eliminated because the inductor current can flow through the SC capacitors. A 1.2-kW prototype inverter is designed and tested to verify the feasibility of the circuit.
17 August 2022 in IEEE Transactions on Power Electronics
This article proposes a three-phase six-switch switching-cell current source inverter (H6-SC-CSI) and a modified switching scheme of space vector pulsewidth modulation (SVPWM). Compared to the conventional three-phase six-switch current source inverter, the H6-SC-CSI has no open-circuit possibility, thus, the inverter reliability is greatly enhanced. In addition, the overlap-time can be minimized; hence, the output waveform quality can be considerably improved. Due to the presence of switching-cell capacitors, a conventional switching sequence of the SVPWM is modified for the inverter to operate properly. A 2.2 kW hardware prototype is built and tested to verify the effectiveness of the proposed PWM.