Vibration energy harvesting is receiving a considerable amount of interest as a means for powering wireless sensor nodes. This paper presents a small (component volume 0.1 cm3, practical volume 0.15 cm3) electromagnetic generator utilizing discrete components and optimized for a low ambient vibration level based upon real application data. The generator uses four magnets arranged on an etched cantilever with a wound coil located within the moving magnetic field. Magnet size and coil properties were optimized, with the final device producing 46 µW in a resistive load of 4 k! from just 0.59 m s! 2 acceleration levels at its resonant frequency of 52 Hz. A voltage of 428 mVrms was obtained from the generator with a 2300 turn coil which has proved sufficient for subsequent rectification and voltage step-up circuitry. The generator delivers 30% of the power supplied from the environment to useful electrical power in the load. This generator compares very favourably with other demonstrated examples in the literature, both in terms of normalized power density and efficiency. (Some figures in this article are in colour only in the electronic version)

This letter introduces a new technique of inkjet printing antennas on textiles. A screen-printed interface layer was used to reduce the surface roughness of the polyester/cotton material that facilitated the printing of a continuous conducting surface. Conducting ink was used to create three inkjet-printed microstrip patch antennas. An efficiency of 53% was achieved for a fully flexible antenna with two layers of ink. Measurements of the antennas bent around a polystyrene cylinder indicated that a second layer of ink improved the robustness to bending.