Zhengbo Qin

Prof. Dr. Zhengbo Qin

orcid

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 August 2010 in Chinese Journal of Chemical Physics
Verified
Journal Article
Closed access
XWXia Wu
Xia Wu
ZQZhengbo Qin
Zhengbo Qin
HXHua Xie
Hua Xie
XWXiao-Hu Wu
Xiao-Hu Wu
RCRan Cong
Ran Cong
ZTZi-Chao Tang
Zi-Chao Tang

2 January 2024 in Journal of Analytical Atomic Spectrometry
Verified
Journal Article
Closed access
PDF file
XYXinyan Yang
Xinyan Yang
XWXin Wang
Xin Wang
DLDongdong Li
Dongdong Li
XZXu Zhang
Xu Zhang
KLKuohu Li
Kuohu Li
XZXianfeng Zheng
Xianfeng Zheng
For analyzing the phosphorus (P) element in water, a liquid aerosol is used as a sampling method of laser-induced breakdown spectroscopy (LIBS). To further improve the detection performance of liquid aerosol-LIBS, the effect of liquid aerosol temperature on the qualitative and quantitative analysis was investigated. With increasing the liquid aerosol temperature, the emission intensity of P increased with the temperature; the threshold energy density (Eth) of P I 213.618 nm decreased from 9.98 to 6.62 J cm−2, and the optimal laser energy density reduced from 26.00 to 18.70 J cm−2. In addition, the LoD of P decreased from 5.22 to 1.81 ppm, and the average relative standard deviation (ARSD) of the intensity of P I 213.618 nm was similar. Furthermore, the R2, the average relative error (ARE), and the root mean square error of cross validation (RMSECV) were improved from 0.9926 to 0.9964, 8.93 to 5.95%, and 4.85 to 2.91 ppm. The results indicate that liquid aerosol temperature affects the sensitivity, LoD, and accuracy of liquid aerosol-LIBS for the analysis of P in water.

26 May 2011 in The Journal of Physical Chemistry A
Verified
Journal Article
Closed access
XWXia Wu
Xia Wu
HXHua Xie
Hua Xie
ZQZhengbo Qin
Zhengbo Qin
KTKai Tan
Kai Tan
ZTZichao Tang
Zichao Tang
XLXin Lu
Xin Lu

25 April 2024 in The Journal of Chemical Physics
Verified
Journal Article
Closed access
PDF file
ZZZhenmei Zhang
Zhenmei Zhang
ZWZhicheng Wang
Zhicheng Wang
QWQiaolin Wang
Qiaolin Wang
XMXiaokang Ma
Xiaokang Ma
ZWZhixie Wang
Zhixie Wang
XZXianfeng Zheng
Xianfeng Zheng
In this work, the threshold photoionization cross sections from the excited states of lutetium and ytterbium atoms were investigated by the laser pump–probe scheme under the condition of saturated resonant excitation. We obtained the resonance enhanced multiphoton ionization spectra of the lutetium and ytterbium atoms of the lanthanide metals in the range of 307.50–312.50 nm and 265.00–269.00 nm, respectively; the photoionization cross sections of the 5d6s(1D)6p(2D05/2) and 5d6s(3D)6p(2P01/2) states of lutetium and the 4f13(2F0)5d6s2(J = 1) states of ytterbium above threshold regions (0.4–1.6 eV) were measured, and measured values ranged from 2.3 ± 0.2 to 17.7 ± 1.5 Mb.

30 November 2021 in ACS Omega
Verified
Journal Article
Open access
WGWei Guo
Wei Guo
XZXianfeng Zheng
Xianfeng Zheng
ZQZhengbo Qin
Zhengbo Qin
QGQiJia Guo
QiJia Guo
LLLei Liu
Lei Liu
Hydrogen production from ethanol reforming using microwave plasmas has great potential. In this study, a microwave plasma torch is used as a plasma source. Air is used as a discharge gas to generate the plasma. Ethanol and air are mixed and injected directly into the plasma reaction zone in a vortex flow. The effects of the oxygen-to-ethanol molar ratio (O2/Et), ethanol flow rate, and absorbed microwave power on the reforming results are investigated. When the O2/Et exceeds 0.9, ethanol is completely converted. The hydrogen selectivity is the largest when the O2/Et is 1.1, which is about 66.5%. The maximum hydrogen production rate is 2.19 mol(H2)/mol(C2H5OH). The best carrier gas residence time is 0.64–0.81 s. An appropriate increase in the ethanol flow rate can improve the ethanol conversion rate and energy efficiency while reducing the hydrogen selectivity and hydrogen yield, so the ethanol flow rate should not exceed 42.1 mL/min. The cost of hydrogen production is minimum [$3.66/kg(H2)] when the ethanol flow rate is 42.1 mL/min. The positive effect of the absorbed microwave power on the reforming reaction is significant, but too much microwave power also reduces energy efficiency. The optimum experimental conditions are an O2/Et of 0.9, an ethanol flow rate of 42.1 mL/min, and an absorbed microwave power of 700 W. The maximum energy yield is 861.91 NL(H2)/kWh at an absorbed microwave power of 700 W. The main reforming products are H2, CO, CO2, CH4, C2H2, C2H4, C2H6, C3H6, C3H8, C4H10n, and C4H10i. The content of C2 or higher hydrocarbons is considerably low. Almost no deposited carbon is generated in the experiment, which means that the design of the reforming system is effective in suppressing carbon deposition.

3 June 2021 in The Analyst
Verified
Journal Article
Closed access
PDF file
JYJingxiong Yu
Jingxiong Yu
YCYuwan Chen
Yuwan Chen
JZJiangle Zhang
Jiangle Zhang
SCShanjun Chen
Shanjun Chen
QWQiaolin Wang
Qiaolin Wang
TZTang Zichao
Tang Zichao
In contrast to the normal LIAD method, the enhanced signals were obtained using substrate-enhanced LIAD source (SE-LIAD) being about 5-fold to 14-fold enhancement.