This article presents the design, implementation and evaluation of an object classification and manipulation system in industrial environments by integrating artificial vision and a MELFA RV-2SDB robotic manipulator. The central problem lies in the need to achieve rapid and accurate classification of objects for palletizing, while ensuring the safety of operators. To address this challenge, a machine vision system based on Logitech C920 HD Pro cameras and force and torque sensors was used on the robotic manipulator. The methodology focused on the use of object and person detection algorithms, as well as direct and inverse kinematics to calculate adaptive movements of the manipulator. The experiments covered evaluation of the system's accuracy and efficiency under various lighting and environmental conditions, as well as testing people detection and geometric shape classification. The results indicated that the system allowed precise and efficient manipulation, adapting in real time to the position and characteristics of the detected objects. The conclusions highlighted the effectiveness of the system in improving productivity and safety in collaborative industrial environments, highlighting the importance of integrating cutting-edge technologies to address automation challenges in the industry.
This study presents an energy-based assessment of a battery electric sport utility vehicle (SUV) tested under high-altitude and high-gradient real-world conditions in Ambato, Ecuador, at approximately 2500 m above sea level. A low-cost instrumentation setup composed of a Global Navigation Satellite System (GNSS) device, a Fluke 393 FC clamp meter, and an On-Board Diagnostics II (OBD-II) interface was used to evaluate zero, positive, and negative road-gradient conditions in Normal and Sport driving modes. The results show that positive gradients increased the acceleration energy from 0.0454 to 0.0658 kWh in Normal mode and from 0.0351 to 0.0535 kWh in Sport mode. In contrast, negative gradients favored regenerative braking, with Normal mode reaching a net energy balance of kWh and a segment-level recovery ratio of 194.38%. This value reflects the contribution of gravitational potential energy. Sport mode showed lower regenerative performance, particularly during uphill operation, where the recovery ratio decreased to 8.96%. These findings demonstrate that low-cost instrumentation can capture representative route-level energy trends and support real-world electric vehicle (EV) energy assessment in topographically complex high-altitude environments.
El proyecto tiene como objetivo diseñar y construir un banco de pruebas para ensayos de resistencia estructural de alas de aviones y alerones que permita comprobar experimentalmente las cargas estáticas sobre la estructura de un ala que se ejercen en seis puntos. El sistema wiffletree (distribución de fuerzas en forma de árbol) mediante un grupo hidráulico genera una fuerza a tracción cuya presión es una carga variable, para simular las cargas estáticas sobre el ala en vuelo (despegue, vuelo horizontal y aterrizaje) y con ello comprobar la resistencia de la composición de los distintos materiales que se utiliza en la industria aeronáutica para la construcción de las alas de los aviones. El motor electro hidráulico acciona al cilindro hidráulico, que transmite la fuerza a la distribución de tensión estática en el ala del avión de forma similar a la que el ala experimenta en vuelo horizontal para la prueba de resistencia estructural. Las celdas de carga miden la fuerza sobre el ala en seis puntos específicos y tienen una comunicación a una tarjeta de adquisición de datos (Arduino) esta información se muestra en un computador que proporciona el estado de fuerza al instante sobre el material. Por lo que el banco de pruebas inicia una etapa de experimentación en el área de materiales y estructuras realizando ensayos a tracción y flexión para el sector de la aeronáutica ligera y la aerodinámica del automóvil.