The results of measurements of atmospheric absorption and the amount of precipitated water on the Suffa Plateau for the period from January, 2015 to November, 2020, are presented. The measurements of atmospheric parameters in the 2 and 3 mm range of the radio waves spectrum were carried out using the MIAP-2 radiometer. The results of more than six years of measurements have show that on the Suffa Plateau, atmospheric parameters in the above range remain fairly stable. The median value of the atmospheric absorption and the amount of precipitated water over the entire observation period were 0.14 and 0.12 Nep and 5.91 and 9.83 mm, respectively, for the ranges of 2 and 3 mm.
Copper cobalt sulfide (Cu-CoS2) nanoparticles (NPs) were synthesized via the co-precipitation method in the present study. The synthesized nanoparticles were employed as photocatalysts for the degradation of two hazardous dyes, Eosin B (EB) and Rhodamine B (RB), under sunlight irradiation. The synthesized nanoparticles were characterized using Energy Dispersive X-ray spectroscopy, Scanning Electron Microscopy, UV-Visible spectroscopy, Fourier Transform Infrared spectroscopy, and X-ray Diffraction analysis. The calculated optical band gap of Cu-CoS2 was 2.06 eV, while the point of zero charge (PZC) was determined to be 7. The XRD results confirmed the crystalline nature of the Cu-CoS2 nanoparticles with an average crystallite size of 28.23 nm. The catalyst exhibited higher photocatalytic degradation efficiency for EB than for RB in single-dye solutions. In contrast, the presence of EB in the binary dye mixture did not significantly influence the degradation of RB. The effects of various operational parameters, including dye concentration, pH, temperature, and catalyst dosage, were systematically investigated. The photocatalytic degradation efficiency of both dyes decreased with increasing initial dye concentration. Optimum degradation conditions for both single and binary dye systems were obtained at dye concentrations of 40:20 μM, pH 5 for EB, pH 9 for RB, and a temperature of 50 °C. The maximum degradation efficiencies achieved in single-dye solutions were 97% for RB and 92% for EB, whereas degradation efficiencies of 98% for RB and 82% for EB were observed in binary dye systems. Furthermore, first-order and second-order kinetic models were applied to evaluate the photodegradation process, and the experimental data showed better agreement with the second-order kinetic model.
14 September 2026 in Astrophysics and Space Science
This study investigates the combination of a ground‐source heat pump (GHP) with a hybrid solar‐geothermal energy system and a machine learning (ML)‐based smart water‐usage monitoring module to improve resource efficiency in green buildings. A random forest (RF) model was trained in MATLAB/Simulink using historical water‐use data and environmental variables to forecast short‐term cooling‐related water demand and to drive prediction‐based operational scheduling (i.e., supervisory adjustments of cooling‐cycle timing and water‐flow operation in the simulation) while maintaining indoor comfort. Simulations were performed for peak summer conditions in Binzhou, China, and Riyadh, Saudi Arabia. In Binzhou, the proposed hybrid system reduced electricity consumption by 31.24% and decreased the cooling water footprint by 19.56% compared with a conventional baseline. The smart water‐management plan in Riyadh cut down on the amount of cooling water used by a lot (up to ~50% on days when demand was high) and lowered the water footprint by 21.20%. These main findings showed that the potential of merging renewable energy combination with data‐driven (DD) resource monitoring led into the lower energy and water footprints across contrasting climatic conditions.
18 November 2026 in Astrophysics and Space Science