Hybrid fiber reinforced thermoplastic composites are receiving important attention in lightweight applications. The fabrication process of hybrid thermoplastic composites is that discontinuous fiber reinforced thermoplastics are injected onto the continuous fiber reinforced thermoplastics by over-molding techniques. The key issue during this process is to get a reliable interfacial bonding strength. To understand the bonding mechanism at the heterogeneous interface of hybrid thermoplastic composites which is difficult to obtain through experimental investigations, a series of molecular dynamic (MD) simulations were conducted in this paper. The influence of processing parameters on the interfacial characteristics, i.e., the distribution of interfacial high-density enrichment areas, radius of gyration, diffusion coefficient and interfacial energy, were investigated during the forming process of a heterogeneous interface. Simulation results reveal that some of molecule chains get across the interface and tangle with the molecules from the other layer, resulting in the penetration phenomenon near the interface zone. In addition, the melting temperature and injection pressure exhibit positive effects on the interfacial properties of hybrid composites. To further investigate the interfacial bonding strength and fracture mechanism of the heterogeneous interface, the uniaxial tensile and sliding simulations were performed. Results show that the non-bonded interaction energy plays a crucial role during the fracture process of heterogeneous interface. Meanwhile, the failure mode of the heterogeneous interface was demonstrated to evolve with the processing parameters.

In this research, the effects of fumed silica (FS) on the Ultraviolet (UV)-ink rheological behavior and processing windows were discussed. Objects using different concentrations of FS inks were printed by the modified UV-Direct ink writing (DIW) printer. The function of fumed silica in the ink-based system has been verified, and the processing scope has been expended with a suitable amount of FS combined with the UV light. The results show that the combination of a suitable amount of FS with the UV-DIW system reaches fast and accurate printing with a larger processing window compared to the non-UV system. However, an excessively high concentration of FS will increase the yield stress of the ink, which also increases the requirement of extrusion unit and the die-swelling effects.