After the Wenchuan earthquake in 2008, the Zipingpu concrete faced rockfill dam (CFRD) was found slabs dislocation between different stages slabs and the maximum value reached 17 cm. This is a new damage pattern and did not occur in previous seismic damage investigation. Slabs dislocation will affect the seepage control system of the CFRD gravely and even the safety of the dam. Therefore, investigations of the slabs dislocation’s mechanism and development might be meaningful to the engineering design of the CFRD. In this study, based on the previous studies by the authors, the slabs dislocation phenomenon of the Zipingpu CFRD was investigated. The procedure and constitutive model of materials used for finite element analysis are consistent. The water elevation, the angel, and the strength of the construction joints were among major variables of investigation. The results indicated that the finite element procedure based on a modified generalized plasticity model and a perfect elastoplastic interface model can be used to evaluate the dislocation damage of face slabs of concrete faced rockfill dam during earthquake. The effects of the water elevation, the angel, and the strength of the construction joints are issues of major design concern under seismic loading.
1 September 2017 in International Journal of Geomechanics
In general, a concrete slab of a concrete-faced rockfill dam (CFRD) is viewed as a macroscopically uniform but microscopically nonuniform material. Study of the damage process of high CFRD subjected to strong motion is crucial for evaluating its safety during an earthquake. Therefore, dynamic analysis with consideration of the nonuniformity of the concrete should reveal the damage mechanism and provide suggestions for engineering design. In this paper, the elastic–brittle damage model proposed by others and applied to the failure simulation of rock and concrete under static loading was developed for this purpose. The impact of the randomness of the modulus of elasticity and tensile strength of concrete on the distribution characteristics of mechanical damage of the face slab of the rockfill dam was studied. The study considered the randomness of the distribution of material parameters combined with principles of statistics, analyzed using two-dimensional finite-element numerical analysis. The results of the calculation indicate that when the randomness of material parameters of the concrete slab was not considered, the stress of the face slab along the slope direction was larger at ∼0.65–0.85H (H is the dam height) and the tensile damage occurred mainly near 0.8H. As the nonuniformity of the concrete material increased, the location in which tensile damage occurred tended to vary but was concentrated mainly in the ∼0.4–0.9H region of the slab. As a consequence, this part of the face slab is the seismic design focus region. Through the use of elastic–brittle micromechanical damage models and by considering the material parameter randomness, the seismic damage process, damage distribution, and typical damage modes can be intuitively illustrated, which makes it easier to understand the weak points of the slab. The results of this study can provide a reference for the seismic design of CFRD.
1 December 2017 in International Journal of Geomechanics
On the basis of a clear understanding of dynamic stress distributions in face slabs of concrete-faced rockfill dams (CFRDs), the cracking failure of a face slab can be avoided using antiseismic design measures. In this study, the distribution of tensile overstresses in face slabs during earthquakes was analyzed while the effects of dam geometries and variable nature of input motions were taken into account. The area of face slab vulnerable to cracking was identified. Furthermore, the installation of a horizontal joint is suggested to mitigate the tensile stress in face slabs when subjected to earthquakes. Three-dimensional (3D) dynamic analyses of CFRDs with various geometries were conducted, and the dynamic slope-direction tensile stresses in face slabs with joints at various positions were compared. The results indicate that peak dynamic slope-direction tensile stress can be significantly decreased by installing the joint where the maximum tensile stress occurs.