This letter presents a new wideband filtering balanced-to-unbalanced out-of-phase power divider (PD) based on a hybrid microstrip/slotline structure. Not only the common-mode signals have been naturally rejected by the slot, but also the filtering differential-mode to single-ended power division is realized. The synthesis method for the proposed PD with desired passband performance is developed to guide the design. The good performance and the consistency between the simulation and measured results verify the design theory.
30 January 2019 in IEEE Transactions on Microwave Theory and Techniques
A new balanced-to-balanced (BTB) rat-race coupling network is presented. The theoretical analysis is performed based on equivalent circuits and design equations are derived to achieve the functions of differential-mode (DM) power division, DM impedance match, common-mode (CM) suppression, and port isolation. The design theories are well vindicated by an exemplary BTB rat-race coupling network centered at 1.8 GHz with a compact size of 0.21λg². The simulated and measured results agree well.
1 January 2014 in IET Microwaves, Antennas & Propagation
This study proposes a new modified optimum wideband bandstop filter (BSF). Detailed theoretical analysis reveals that five transmission zero frequencies appear in the proposed BSF's response to compose an ultra‐wide BSF with stiff rejection. Moreover, the filter's bandwidth, stopband rejection level and passband performance can be tuned flexibly by changing the impedances of the configuration. Both the simulations and measurements of the fabricated filter demonstrate good wideband BSF performance including an ultra‐wide 20 dB rejection bandwidth of 140%, sharp attenuation rates more than 227.3 dB/GHz at both skirts, lower passband insertion loss less than 1.5 dB at both lower and upper passband and very compact size of λ g2 .
A Wilkinson power divider (PD), which can suppress the second, third, and fourth harmonics is proposed. The PD is implemented based on an asymmetric meta-structure. The meta-structure is constructed be combing defect ground structure (DGS) and spoof surface plasmon polariton (SSPP). It can not only realize the impedance conversion function in the operating frequency band, but also realize the suppression of the second, third, and fourth harmonics. The simulation and measurement results show that this structure can achieve −32 dB suppression for the second harmonic, −31 dB suppression for the third harmonic, and −28 dB suppression for the fourth harmonic respectively.
22 May 2019 in IEEE Transactions on Microwave Theory and Techniques
In this paper, a new method to develop balanced-to-unbalanced (BTU) filtering out-of-phase power divider (PD) is presented. Based on the comparison between BTU filtering out-of-phase PD and balanced-to-balanced (BTB) filter, it is found that the BTU filtering out-of-phase PD can be constructed by combining a BTB filter and an additional parallel four-port network. The design equations are derived and corresponding circuit models are given. Finally, a prototype is designed to verify the theoretical prediction. The design procedure and parameter selection are detailed. The good performance and the consistency between the simulated and measured results verify the design theory.