This paper presents the results of the study of carbon films deposited on substrates of quartz, mica and silicon by the method of electron paramagnetic resonance (EPR). This study has identified the dependences of the intensities of the EPR signal, the g- factor, and the line width on the temperature of carbon films on various substrates with perpendicular and parallel arrangement of the sample plane relative to the orientation of the magnetic field are presented. The results of this study show that the dependence of the line width on temperature measurements does not change under both conditions for recording the EPR spectra. The research has also shown that with increasing temperature, the normalized intensity of the EPR signal line increases when carbon is deposited on various substrates (quartz, mica, and silicon) by the method of plasma decomposition of a mixture of CH4 and H2.
This research paper presents the results of obtaining carbon films on various substrates (quartz, mica, and silicon) at temperatures from 0 °C (initial) to 800 °C through plasma chemical vapor deposition. The carbon films obtained on various films were studied using the method of electron paramagnetic resonance (EPR). EPR measurements were carried out on twenty samples at a perpendicular and parallel arrangement of the sample plane concerning the orientation of the magnetic field. When measuring the resonance conditions by changing the magnetic field, an EPR signal appeared in all of the deposited samples. The paper presents a general view of the EPR spectrum in all of the samples, including the signal intensity, g-factor, line widths, and normalized signal intensity of the carbon films on various substrates at temperatures from 0 °C to 800 °C. Studies show that with an increase in temperature, the normalized intensity of the EPR signal line increases during the deposition of a carbon in all deposited substrates (quartz, mica, and silicon) using the method of plasma decomposition of a mixture of methane and hydrogen.
We present an open, scripted reconstruction pipeline for the ADRON-55 ionization calorimeter at the Tien Shan station (3340 m a.s.l.) and apply it to events from 2021 and 2023. It assembles overlapping chamber sections, applies data-driven integrity and good-run selection (16.3% flagged), and fits three-dimensional directions from hadron-block planes with material-based weights. Plane occupancy falls with depth to 0.75 (X) and 0.61 (Y) at the deepest plane of each projection, while per-channel deposition is nearly uniform across X planes, revealing a projection-dependent efficiency offset whose size, and for the deepest plane pair whose sign, depend on the amplitude threshold. One-pitch lateral profiles resolve a narrower gamma-block component, RMS against m; the gamma figure is an upper limit, since the events carrying half its amplitude clip the digitizer, and without them it is 0.507 m. For 990 single tracks with three active planes in each projection, the azimuthal flatness statistic improves from to 15.8 after assembly, seeding, and alignment. We then locate the residual: in four fifths of that sample a plane is lit edge to edge and carries no core, so its centroid reports the aperture rather than the particle, and the alignment maps those events onto a zero-slope line that pins their azimuth to the detector axes. Removing them leaves , and 1.2 on events held out of a re-derived alignment; a detector-level simulation carrying the measured channel efficiencies then reproduces that sub-sample with an isotropic parent. The code and diagnostics are released, making the figures reproducible from raw data.
Солнечная энергетика на текущий момент – самый быстроразвивающийся сектор энергетики. Солнечные электростанции успешно конкурируют с традиционными источниками энергии по стоимости за единицу генерируемой энергии. Данная статья посвящена одному из методов очистки кремния без газовой фазы, для очистки использовался метод шлакового рафинирования. Очистка металлургического кремния проводилась шлаковым методом. Был исследован металлургический кремний, полученный классическим карботермическим методом. Затем была опробована металлургическая очистка шлаковым рафинированием, с использованием шлаков различного состава. Всего было рассчитано 9 различных новых составов для проведения 9 процессов шлакового рафинирования. Кремний, полученный в результате всех проведенных плавок, был проанализирован на содержание примесей. Solar energy is the fastest growing branch of energy. Installed capacities are in fact ahead of all development forecasts, in addition, solar power plants successfully compete with traditional energy sources in terms of cost per unit of generated energy. This article is devoted to one of the methods of silicon purification without a gas phase, the slag refining method was used for purification. This paper presents the results of testing the first phase of metallurgical silicon purification. Purification was carried out by a slag refining method. Metallurgical silicon produced by the classical carbothermic method was investigated. Then a metallurgical purification by slag refining was tried, using slags of different composition. A total of 9 different new compositions were calculated for 9 slag refining processes. Silicon obtained as a result of all melts was analyzed for impurities.
Күн сапалы кремний алу үшін металлургиялық кремнийді химиялық тазарту әдісі анықталды. Шлакты тазарту балқыманың кремний фазасына және әртүрлі оксидтер мен силицидтерден тұратын екінші фазаға бөлінуіне әкелетіндіктен, қожды алдын ала тазарту әдісі қышқылды тазарту кезінде металлургиялық кремнийдің жоғары тазалығына қол жеткізу мүмкіндігін ашатыны көрсетілген. Кремний қоспалары кремний түйіршіктерінің шекараларында шоғырланған екінші фазаға өтеді, бұл одан кейінгі қышқылды тазарту барысындағы ластану деңгейін айтарлықтай төмендетеді. Бұл зерттеуде металлургиялық кремнийді химиялық өңдеу кезеңдері әзірленді, материалдың бөлшектер мөлшері бойынша таралуы, сілтісіздендіру ерітіндісінің құрамы, химиялық тазалау процесінің уақыты мен температурасы оңтайланды. Қоспа элементтері көмегімен ұнтақты кремний материалының аса тазалығына қол жеткізілді Methods of chemical purification of metallurgical silicon for obtaining solar-grade silicon have been developed. Preliminary slag refining opens up the possibility of achieving high purity of metallurgical silicon during acid purification due to the fact that slag refining leads to melt stratification into a silicon phase and a second phase consisting of various oxides and silicides. Impurities from silicon pass into the second phase, which is concentrated at the boundaries of silicon grains. The stages of chemical processing of metallurgical silicon have been developed, the granulometric composition of the material, the composition of the leaching solution, the time and temperature of the chemical purification process have been optimized. High purity of powdered silicon material for target impurity elements has been achieved Отработаны методы химической очистки металлургического кремния для получения кремния солнечного качества. Предварительное шлаковое рафинирование открывает возможность достижения высокой чистоты металлургического кремния в ходе кислотной очистки благодаря тому, что шлаковое рафинирование приводит к расслоению расплава на фазу кремния и вторую фазу, состоящую из различных оксидов и силицидов. Примеси из кремния переходят во вторую фазу, концентрирующуюся на границах зерен кремния, что делает последующую кислотную очистку весьма эффективной для уменьшения уровня загрязнений. Отработаны этапы химической обработки металлургического кремния, оптимизированы гранулометрический состав материала, состав раствора для выщелачивания, время и температура процесса химической очистки. Достигнута высокая чистота порошкового кремниевого материала по целевым примесным элементам
15 April 2021 in NEWS OF THE NATIONAL ACADEMY OF SCIENCES OF THE REPUBLIC OF KAZAKHSTAN
When analyzing the results obtained in measurements on neutron detectors with a low energy threshold, it is necessary to know the dependence of the neutron detection efficiency on their kinetic energy in information channels of various types, both for "open" neutron counters, and for counters surrounded by a moderator. Having a physical model of particle interactions based on the Geant4 package, it is possible to calculate the detection efficiency for various types of detectors, which are used in experiments conducted at the Tien Shan high-mountain station related to the registration of a neutron flux. The paper presents several simulation models developed for neutron detectors.