In this study, numerical simulations for a single fixed truncated circular cylinder in regular waves were conducted to investigate the nonlinear wave run-up under various dampers and wave period conditions. The present study used the volume of fluid (VOF) technique to capture the air-water interface. The unsteady Reynolds-averaged Navier–Stokes (URANS) equation with the k– ϵ turbulence model was solved using the commercial computational fluid dynamics (CFD) software STAR-CCM+. First, a systematic spatial convergence study was conducted to assess the performance and precision of the present numerical wave tank. The numerical scheme was validated by comparing the numerical results of wave run-up on a bare truncated cylinder with the experimental results, and a good agreement was achieved. Then, a series of parametric studies were carried out to examine the wave run-up time series around the truncated cylinder with single and dual dampers in terms of the first- and second-order harmonic and mean set-up components. Additionally, the local wave field and the flow velocity vectors adjacent to the cylinder were evaluated. It was confirmed that under short wave conditions, the high position of the damper led to a noticeable increase in the wave run-ups with significant changes in the first- and second-order harmonic components.
In this study, a systematic numerical study on design optimization was conducted for a tension leg platform (TLP)-type floating offshore wind turbine (FOWT), aiming to improve hydrodynamic performance, tendon behavior, and cost-effectiveness. Six design variables associated with hull geometry and tendon properties—pontoon length (PL), pontoon width (PW), platform draft (PD), main column diameter (CD), tendon pre-tension (Pre), and axial stiffness (EA)—were considered. For the global performance analysis, hydrodynamic coefficients were first obtained in the frequency domain, and motion and tendon tension responses were subsequently evaluated in the time-domain under a survival condition representative of a Southeast Asian site. A surrogate model based on the response surface method (RSM) was developed to predict platform responses across the design space. Multi-objective optimization was then performed using the non-dominated sorting genetic algorithm II (NSGA-II), yielding Pareto-optimal solutions that reveal trade-offs among competing performance metrics. The proposed framework is intended to provide Pareto-optimal design candidates for preliminary TLP-FOWT design, while the selection of a final design requires project-specific criteria and is beyond the scope of the present conceptual study. The optimization results show that the tendon tension can be effectively reduced while maintaining cost efficiency by increasing the pontoon length and slightly decreasing the tendon axial stiffness. For the tension–surge motion optimization, the Pareto-optimal solutions provide a balanced trade-off, where tendon tension is clearly reduced with only a slight increase in surge motion. In addition, the cost–nacelle acceleration optimization shows that nacelle acceleration can be further reduced by increasing the platform draft and pontoon length, although this is accompanied by a slight increase in the cost index. These findings provide practical insights for balancing global performance and cost in TLP-type FOWT design.
Under extreme environmental conditions, large relative motions of a floating production storage and offloading unit (FPSO) can lead to green water events, which poses a significant risk of structural damage to topside equipment and deck structures. In this study, the green water height was quantitatively evaluated under design wave conditions using computational fluid dynamics (CFD) simulations. First, the CFD simulation setup was validated by comparing the relative wave elevations obtained from both experimental and CFD results. Subsequently, three types of design waves – regular design wave, New Wave, and most likely extreme response (MLER) wave - were employed to investigate the characteristics of green water at 71 deck positions through local motion response and wave pattern analysis. The maximum height of green water on the deck was observed when the relative wave motion exceeded the deck level through the bow flare, with the highest values occurring under the regular design wave condition, followed by the MLER and then New Wave conditions. It is concluded that the MLER method, based on the relative wave motion RAOs, offers a superior design wave approach for green water estimation compared to the regular design wave and New Wave methods.