Ju Sung Kim

Ju Sung Kim

Auto-generated profile, based on publicly available information

Ju Sung Kim


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 December 2023 in Ocean Engineering
Verified
Journal Article
Closed access
HPHyo-Jin Park
Hyo-Jin Park
JKJeong-Seok Kim
Jeong-Seok Kim
BNBo Woo Nam
Bo Woo Nam
JKJoo-Sung Kim
Joo-Sung Kim

28 February 2026 in Journal of Ocean Engineering and Technology
Verified
Journal Article
Open access
PDF file
JJJae Min Jeon
Jae Min Jeon
ZSZhenhao 학생 Song
Zhenhao 학생 Song
JKJoosung Kim
Joosung Kim
Bo Woo NamBo Woo Nam
Bo Woo Nam
Under extreme environmental conditions, large relative motions of a floating production storage and offloading unit (FPSO) can lead to green water events, which poses a significant risk of structural damage to topside equipment and deck structures. In this study, the green water height was quantitatively evaluated under design wave conditions using computational fluid dynamics (CFD) simulations. First, the CFD simulation setup was validated by comparing the relative wave elevations obtained from both experimental and CFD results. Subsequently, three types of design waves – regular design wave, New Wave, and most likely extreme response (MLER) wave - were employed to investigate the characteristics of green water at 71 deck positions through local motion response and wave pattern analysis. The maximum height of green water on the deck was observed when the relative wave motion exceeded the deck level through the bow flare, with the highest values occurring under the regular design wave condition, followed by the MLER and then New Wave conditions. It is concluded that the MLER method, based on the relative wave motion RAOs, offers a superior design wave approach for green water estimation compared to the regular design wave and New Wave methods.

31 December 2022 in Journal of Ocean Engineering and Technology
Verified
Journal Article
Open access
PDF file
GSGisu Song
Gisu Song
SLSeung Jae Lee
Seung Jae Lee
JKJu Sung Kim
Ju Sung Kim
The azimuth thruster is mainly installed on a vessel that requires a dynamic positioning (DP) function for special purposes. When the azimuth thruster on a vessel operates for DP, the thrust loss is induced by the thruster-hull interaction. This study examined the influence of boundary conditions in numerical simulations for predicting thrust loss. Wind turbine installation vessels (WTIV) and floating production storage and offloading (FPSO) were chosen as a target vessels. In this study, two types of boundaries were defined. The first consideration is that the boundary condition was assigned with consideration of the azimuth angle of the thruster, whereas it is fixed regardless azimuth angle of the thruster. The predicted thrust loss according to these boundary conditions showed a difference. This observation originated from the current load of the vessel. Therefore, the boundary conditions for which the current load is not induced need to be designated to obtain a realistic thrust loss in a numerical simulation.