Non-uniform heat flux in high-power electronic devices can induce local hotspots. To address hotspot thermal management, a hybrid microchannel heat sink featuring micro pin-fins with secondary channels (MPSCs) is proposed. Straight microchannels are used in the low-heat-flux region, while staggered pin-fins are arranged in the central hotspot region. Five models are considered: solid pin-fins without secondary channels (M1) and pin-fins with one-, three-, four-, and six-directional secondary channels (M2–M5). Over Re = 200–800, the thermal resistance of M3 is reduced by up to 43.3% compared with the SPMS, and the maximum PEC reaches 1.178. MPSC structures achieve better cooling at lower pumping power. At similar pumping power, the thermal resistance of M3 is 36.8% lower than the minimum value attainable by the SPMS. However, the marginal reduction in thermal resistance gradually weakens as the pumping power increases. The effects of hotspot heat flux and relative pin-fin height are investigated. MPSCs can withstand higher heat loads. Under a hotspot heat flux of 800 W/cm2, the maximum temperature of M3 remains below the safety threshold. Relative pin-fin height has a coupled effect on the thermal–hydraulic performance. At Re = 800, the PEC of M3 at RPH = 0.9 is about 2.8% higher than that at RPH = 1.0, and a PEC fitting equation is developed. The results show that the hybrid micro pin-fin heat sink with secondary channels disrupts the thermal boundary layer through internal flow diversion and local disturbance, thereby balancing hotspot suppression and pressure drop control. This design provides a reference for hotspot thermal management and thermal–hydraulic optimization of microchannel heat sinks.
Reliable state of health (SOH) estimation provides important support for safety management and efficient operation of lithium-ion battery energy storage systems. To address the limitations of existing SOH estimation methods in terms of feature interpretability, joint modeling of local variations and overall morphological characteristics within each feature segment, and the rationality of model hyperparameter configuration, this study proposes a hybrid data-driven SOH estimation method integrating interpretable feature construction, an improved Transformer, and Bayesian optimization (BO). Specifically, raw charging data are first converted into incremental capacity (IC) curves based on incremental capacity analysis, and IC peaks are dynamically located in different cycles. Local voltage–capacity segments around the IC peak voltage are then extracted as interpretable input features closely related to battery aging. Subsequently, the Transformer encoder is improved by incorporating patch embedding and a multi-head differential self-attention mechanism, thereby enhancing the model’s ability to jointly capture local variations and overall morphological characteristics within each cycle-wise feature segment. BO is further employed to adaptively optimize key model hyperparameters. Experimental results on the CALCE-CS2 and CALCE-CX2 battery datasets show that the proposed BO-PatchDiffFormer model can provide accurate and stable SOH estimation in both comparative and generalization experimental scenarios. Compared with the best-performing baseline model, the maximum reductions in RMSE and MAE on the four CS2 test batteries reach 31.81% and 23.76%, respectively. In the generalization experiments, the average RMSE and MAE on the two CX2 test batteries are 1.6039% and 1.3081%, respectively. In addition, the maximum model size is only 2.07 MB, and the single-sample inference time remains within 0.84–1.18 ms, indicating good potential for practical deployment and application.