Dr. Michael Norderhaug Getz

Dr. Dr. Michael Norderhaug Getz

orcid

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 July 2019 in Scientific Reports
Verified
Journal Article
Open access
PDF file
DGDr. Michael Norderhaug Getz
Dr. Michael Norderhaug Getz
ONOla Nilsen
Ola Nilsen
PHPer-Anders Hansen
Per-Anders Hansen
Below the Earth’s crust, temperatures may reach beyond 600 K, impeding the batteries used to power conventional thermometers. Fluorescence intensity ratio based temperature probes can be used with optical fibers that can withstand these conditions. However, the probes tend to exhibit narrow operating ranges and poor sensitivity above 400 K. In this study, we have investigated single and dual layered YVO4: Ln3+ (Ln = Nd, Sm, Eu, Dy, Ho, Er, Tm, Yb) thin films (100–150 nm) for use in fluorescence intensity ratio based temperature sensors in the 300–850 K range. The type of lanthanide emission can be fine-tuned by adjusting the thickness of each layer, and the layered structure allows for emission from otherwise incompatible lanthanide pairs. This novel multi-layered approach enables high sensitivity over a broad temperature range. The highest relative sensitivity was achieved for a dual layered YVO4: Eu3+/YVO4: Dy3+ sample, exhibiting a maximum sensitivity of 3.6% K−1 at 640 K. The films were successfully deposited on all tested substrates (silicon, iron, aluminum, glass, quartz, and steel), and can be applied homogenously to most surfaces without the use of binders. The films are unaffected by water, enabling non-contact temperature sensing in water, where IR thermometers are not an option.

2 August 2017 in Journal of Materials Chemistry C
Verified
Journal Article
Closed access
PDF file
DGDr. Michael Norderhaug Getz
Dr. Michael Norderhaug Getz
PHPer-Anders Hansen
Per-Anders Hansen
OFOystein Slagtern Fjellvag
Oystein Slagtern Fjellvag
MAMohammed A. K. Ahmed
Mohammed A. K. Ahmed
HFHelmer Fjellvåg
Helmer Fjellvåg
Ola NilsenOla Nilsen
Ola Nilsen
Thin films of YVO4:Yb3+ exhibiting intense NIR emission have been deposited by atomic layer deposition. The NIR emission is attributed to a quantum splitting process that could be used to enhance the efficiency of solar cells.

23 January 2017 in RSC Advances
Verified
Journal Article
Open access
PDF file
DGDr. Michael Norderhaug Getz
Dr. Michael Norderhaug Getz
PHPer-Anders Hansen
Per-Anders Hansen
HFHelmer Fjellvåg
Helmer Fjellvåg
Ola NilsenOla Nilsen
Ola Nilsen
In the present contribution we assess the luminescent properties of amorphous europium titanium phosphate thin films. The films have been deposited by atomic layer deposition, using the precursor combinations Eu(thd)3 (thd = 2,2,6,6-tetramethyl-3,5-heptanedione) and O3, TiCl4 and H2O, and Me3PO4, H2O and O3 at a deposition temperature of 300 °C. UV light is absorbed in the (TiO6)8− complex and subsequently transferred to Eu3+, from which characteristic visible red emission takes place. The inclusion of phosphate is expected to reduce the symmetry around Eu3+ compared to the pure oxide structure, which should increase the f–f transition rate and improve the luminescence efficiency. The as deposited samples display a high degree of photobleaching when subjected to UV or X-rays. The bleaching rate has been quantified for the as deposited samples and can be controlled by adjusting the Ti-content in the samples. Annealing the samples at 500–700 °C increases both the photostability and the luminescence of all compositions, while annealing at 800 °C and above quenches the Eu3+ luminescence. Annealing at 1000 °C results in a broad NIR emission centred around 820 nm for most of the samples. The structure, roughness, thickness and composition of the deposited films have been studied by X-ray diffraction, atomic force microscopy, ellipsometry, and X-ray fluorescence, respectively. The optical properties have been characterized with excitation and photoluminescence spectroscopy and spectroscopic ellipsometry, while field emission scanning electron microscopy has been used to determine the morphology of the annealed samples.

24 May 2021 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
DGDr. Michael Norderhaug Getz
Dr. Michael Norderhaug Getz
MPMarco Povoli
Marco Povoli
EMEduard Monakhov
Eduard Monakhov
The effect of the native silicon oxide layer on the passivation properties of Al2O3 on p-type Si surfaces has been investigated. This was done by comparing effective carrier lifetime, surface saturation current density, fixed charge, and density of interface states of samples, where the native oxide was not removed prior to Al2O3 passivation, with samples subjected to a 3 min HF-dip. The sample with the native oxide exhibits excellent surface passivation post-annealing, with a surface saturation current density of 13 fA/cm2 and significantly longer effective lifetime compared to the sample, where the native oxide was removed. Capacitance–voltage measurements of a sample with the native oxide revealed a remarkably low density of interface states (1010 eV−1 cm−2), almost three times lower than a sample where the native oxide was removed prior to Al2O3 deposition. The results indicate that a thin layer of native oxide improves the Al2O3 surface passivation of silicon.

17 April 2023 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
DGDr. Michael Norderhaug Getz
Dr. Michael Norderhaug Getz
MPMarco Povoli
Marco Povoli
OKOzhan Koybasi
Ozhan Koybasi
TSTomáš Slavíček
Tomáš Slavíček
EMEduard Monakhov
Eduard Monakhov
Al2O3 has emerged as the surface passivation material of choice for p-type silicon in photovoltaics and has also become a candidate for passivating Si-based radiation sensors. However, the surface passivation of Al2O3 has been shown to degrade when exposed to gamma-radiation, making it of interest to determine methods of depositing Al2O3 that minimize the radiation-induced degradation on the surface passivation. In this study, we investigate the long-term stability and gamma-radiation hardness of Al2O3 prepared using the TMA+H2O+O3 precursor combination and how the pretreatment, the deposition temperature, and the film thickness affect the density of interface states, Dit, and fixed oxide charge, Qfix, before and after gamma-irradiation. We find that the surface saturation current density, J0s, of silicon passivated by Al2O3 increases after annealing but stabilizes over time depending on the Al2O3 thickness. Samples with thicknesses of 60 nm stabilize over days. J0s stabilizes at lower values with increased Al2O3 thickness. After exposure to 1 Mrad gamma-radiation, the samples still exhibit low Dit and high Qfix, with the best performing sample having a Dit of 1.5 × 1010 eV−1 cm−2 and a Qfix of −3.1 × 1012 cm−2. The deposition temperature appears to indirectly affect radiation hardness, owing to its impact on the hydrogen concentration in the film and at the Si–SiOx–Al2O3 interface. Lifetime measurements after irradiation indicate that Al2O3 still passivates the surface effectively. The carrier lifetime and Qfix can largely be recovered by annealing samples in O2 at 435 °C.

15 February 2017 in Dalton Transactions
Verified
Journal Article
Open access
PDF file
DGDr. Michael Norderhaug Getz
Dr. Michael Norderhaug Getz
PHPer-Anders Hansen
Per-Anders Hansen
MAMohammed A. K. Ahmed
Mohammed A. K. Ahmed
HFHelmer Fjellvåg
Helmer Fjellvåg
Ola NilsenOla Nilsen
Ola Nilsen
Thin films of YbVO4 displaying UV to NIR down conversion have been deposited by atomic layer deposition and crystallized through a flux aided process.