A modular, automated photoreactor system for CO 2 hydrogenation enables precise conversion into methane or carbon monoxide. The carbon monoxide is subsequently utilized in carbonylation reactions, advancing sustainable synthesis and CO 2 utilization.
Using a colloidal suspension, tungsten oxide thin films (150 nm) have been prepared via ultrasonic spray deposition using two different current collectors, namely TiN and Pt. First, the precursor chemistry was studied, revealing that the tungsten present is reduced due to the formation of chlorine gas. Due to a dehydrogenation 1,1-diethoxyethane (DEE) and hydrogen chloride (HCl) evolve from the precursor, reducing the chloride content of the precursor. The thin films were annealed at 400 and 500 °C, yielding tetragonal tungsten oxide without the presence of chlorides. Electrochemical analysis indicated that the TiN current collector has a pronounced positive effect on cycling behavior of the WO3 thin film. A higher annealing temperature yields an improved performance, but annealing at temperatures as low as 400 °C also yielded electrochemically active WO3. The current study presents a versatile method to produce electrochemically active tungsten oxide thin films with a high volumetric capacity (640 mA h cm−3) at relatively low temperature to be applied in all-solid-state Li-ion batteries.
The transition to a sustainable energy system is crucial to meet climate targets and reduce fossil fuel dependence. Solar hydrogen systems offer a promising route for renewable hydrogen production. This study presents a techno-economic assessment of hydrogen production using integrated solar hydrogen panels combined with balance-of-plant equipment such as compressors. The analysis combines detailed Aspen Plus process design with an hourly solar model to capture the impact of system scale and hydrogen storage under intermittent operation. Results show that large-scale integrated systems can achieve costs comparable to photovoltaic–electrolyzer setups, suggesting a feasible and streamlined alternative. System scale is the dominant factor influencing the levelized cost of hydrogen (LCOH). At a small scale (1000 panels), the LCOH is about 49 €/kg. Including hydrogen storage reduces costs by up to 40% through better utilization of capital-intensive components. At larger scales, costs decrease substantially: 100,000 panels yield an LCOH of 9.1 €/kg, and 10 million panels reach 7.3 €/kg. In these large systems, storage slightly increases costs because added capital expenditures outweigh operational gains. If solar-to-hydrogen efficiency improves to 23% and panel costs drop to 120 €/m2, hydrogen could be produced at around 3.8 €/kg. These findings emphasize the importance of scale, efficiency gains, and cost reduction to enable affordable renewable hydrogen directly from sunlight and water.