Short interval and continuous high‐impact experiments have very significant engineering application values, and impact acceleration is a key performance index of these dynamic experiments. This paper aims at the shortcomings of the existing multiple high‐impact equipment, designs a new type of multiple high‐impact equipment based on the collision contact mode by multiple impact components, and studies the composition of acceleration in impact experiment. The research results indicate that it is unreasonable to analyze the impact acceleration only based on rigid body dynamics theory and ignore the effect of the stress wave loading during an impact experiment. On this basis, a line contact model is adopted to modify the equivalent damping coefficient and obtain a nonlinear spring damping contact force model based on the line contact, and then a rigid body acceleration model of the impact experiment is established. A stress wave acceleration model is also established based on the one‐dimensional stress wave transfer theory of the tested specimen. The established acceleration model is verified by different corresponding impact experiments. At the same time, the collision contact process of the impact experiment is also simulated which is combined with the finite element method. The simulation results were fundamentally consistent with the experiments and a fact that proves the correctness of analysis and modeling. The research results not only provide theoretical support for the design and analysis of the impact equipment and a new idea to realize multiple high‐impact loading but also provide a methodology to be applied to the analysis and modeling of acceleration for similar high‐impact experiments.
To address the damage and failure of electromechanical structures such as Printed Circuit Board (PCB) modules and battery assemblies under multiple impacts, this study combined experimental and modeling approaches to quantitatively investigate the influence of target material mechanical properties on impact acceleration characteristics. Quasi-static tensile/compression tests, split-Hopkinson pressure bar dynamic compression tests, and sequential multiple-target impact experiments were conducted on nine metallic materials, providing constitutive parameters and impact response data. Variance analysis revealed that material type significantly affected acceleration characteristics (p ≤ 1.62 × 10−5), whereas the target position in the impact sequence was statistically insignificant (p ≥ 0.89). Quantitative prediction models were established for different acceleration characteristics: Ridge regression (α = 0.1) was employed for Peak 1–Peak 3, Duration 1, and Duration 3, while linear regression was used for Duration 2. The results quantitatively demonstrated that the elastic modulus was positively associated with both peak acceleration and duration, while dynamic compressive yield strength exhibited a significant negative influence. This work establishes a preliminary quantitative predictive framework that provides guidance for target material selection in sequential multiple-target impact experiments and offers an experimental approach for generating tunable overload responses in high-intensity impact testing of electromechanical components.
In impact testing, evaluating multiple-impact signals is critical for verifying whether a test setup can reproduce penetration response signals and ensure reliable results. To overcome the limitations of traditional methods, including incomplete indicator coverage, subjective weighting, and poor consistency, this study proposes a fuzzy comprehensive evaluation (FCE) framework based on time–frequency features and combined weighting. Using multi-layer penetration response signals as the matching target, a multidimensional indicator system covering time-domain features, frequency-domain features, and signal quality and stability is established. A combined weighting method integrating AHP, EWM, and CRITIC is then developed, and subjective and objective weights are fused using the geometric mean method. A fuzzy comprehensive evaluation model is used to quantify the matching degrees of multiple sets of multiple-impact signals, and robustness is verified through weight consistency tests and sensitivity analysis. The results show that the evaluated signal sets are rated “Excellent”. Under reasonable weight combinations, the probability of obtaining an “Excellent” result reaches 99.94%, and the maximum variation caused by a ±10% perturbation in a single indicator weight is only 0.0087. The proposed framework provides a practical tool for evaluating multi-layer penetration response simulations and can be extended to other complex dynamic signal-matching problems.