Purpose: Many factors can affect the aesthetics of dental restorations, including the instrumental techniques used in shade matching, and can lead to clinical failure. The aim of this study was to investigate the effectiveness of using the cross‐polarization digital photograph technique and intraoral scanners for shade matching, and also evaluate the effect of the level of clinical experience on shade matching success.Materials and Methods: Color analysis was performed on the maxillary right central incisors of 10 subject models with Vita Easyshade. Intraoral scanning was performed 10 times on each model using TRIOS 3 and color analysis was performed from the same spot. Then cross‐polarized and non‐polarized photographs of the models were taken with standard settings using a gray reference card. Each shade tab of the Vita System 3D‐Master scale was also photographed with two different polarization techniques. Four groups (n = 12), including prosthodontics faculty staff, postgraduate students in prosthodontics, undergraduate students, and dental technicians matched the shade tabs and the model photographs obtained with both techniques on a standardized computer screen. Finally, the color differences between the shade tabs and maxillary central incisors matched by observers from four different groups were recorded using a colorimeter, Classic Color Meter, in accordance with the CIELAB system and CIEDE2000 (ΔE00) values were calculated. The data were compared with the acceptability threshold of 1.80 for ΔE00. The data obtained from the observers were analyzed with IBM SPSS Statistics 26.0 Release Notes program. Independent Samples t‐test was used to compare normally distributed data according to binary groups. The level of significance was 0.05.Results: A statistically significant difference was found in the shade matching on photographs taken with different techniques in postgraduate students (p = 0.02). Also, there was a statistically significant difference in success between the groups that made shade matching based on photographs obtained with the non‐polarization technique (p = 0.00). The undergraduate students achieved statistically significantly lower results than all other groups (ΔE00 = 5.57 ± 1.07). The kappa value between the intraoral scanner and spectrophotometer results was 0.10, and this value was not statistically significant (p = 0.32).Conclusions: The cross‐polarization technique used especially for shade matching is not superior to the non‐polarization technique. Academic and clinical experience might be correlated with shade‐matching success with the non‐polarization technique. The clinical acceptability threshold could not be achieved in the shade matchings made on digital photographs taken with both techniques. Shade matching performed with an intraoral scanner did not yield reliable results.
1 January 2025 in The Journal of Advanced Prosthodontics
Primary stability is a perquisite for achieving successful osseointegration. Additionally thermal effect of implant bed preparation plays an important role in success of a dental implant. This ex vivo study was conducted to compare one step implant specific osteotomy and conventional osteotomy in terms of primary stability and thermal changes during surgery. Forty eight implants were inserted into the sheep iliac crest bones each with a safe distance to each other and divided into six groups. In two of the groups implant specific osteotomy and in the remaining 4 groups conventional osteotomy was performed. In the groups, the primary stability of the trioval implants designed for the implant specific osteotomy were compared with the oval active threaded implants. The two osteotomy methods were also compared. Additionally the thermal changes during the two osteotomy methods were compared using a double-channel temperature monitoring device. Statistically significant differences (P <.05) were observed between the stability groups and the thermal evaluation groups (P <.05). Implant specific osteotomy revealed significantly higher stability than the conventional osteotomy (P <.001). Osteotomy without irrigation caused significantly higher thermal changes than the conventional osteotomy wit irrigation (P <.001). Although the implant specific osteotomy reveals better primary stability, it causes higher temperature during drilling. However, since this increase is within the limits and doesn’t cause a risk in terms of osseointegration, it may be used safely in clinical practice.
12 May 2025 in Journal of Stomatology Oral and Maxillofacial Surgery
Aim: This study proposes to investigate the influence of various surgical guide designs on the generation temperature in the cortical and cancellous regions of the osteotomy site. The working hypothesis was that open guides are more efficacious in controlling excessive heat generation in cortical and cancellous areas. Materials and Methods: Implant osteotomy was performed on specimens simulating D3 bone density using surgical guides produced with three different designs: an open guide, a guide with an external cooling channel, and a closed guide. Temperature increases occurring in the cortical layer from a depth of 2 mm and in the cancellous layer from a depth of 10 mm were measured with type K thermocouples. Results: Temperature averages recorded from a depth of 2 mm during osteotomy show statistically significant differences between groups ( p = .003). The temperature rise in the group using a closed surgical guide was significantly higher than in the groups using an open surgical guide and a surgical guide with an external cooling channel on the cortical layer, while the temperature increase did not show any significant difference in both cortical and cancellous layers between the open guide and guide with external cooling channel. Temperature averages recorded from a depth of 10 mm do not show statistically significant differences between groups ( p = .054). Conclusion: Using open surgical guides or surgical guides with external cooling channels among the guided surgical systems is a more reliable way to keep the thermal increase under control.