Real-hardware deployment of adaptive manipulator controllers remains difficult because assumptions made in paper-level formulations are weakened by friction, encoder quantisation, current limits, communication latency, and low-speed actuation nonlinearities. This paper investigates that deployment gap for a recent Nussbaum-function PID controller by translating it from a simulation-level formulation into direct current-command control on a Niryo NED3 Pro actuator. To isolate deployment-layer behaviour from the whole-arm Coriolis, centrifugal, and gravity dynamics, the study is centred on a single decoupled actuator (Dynamixel ID 6, distal wrist) under long-horizon sinusoidal tracking around a fixed operating region. A direct transfer of the baseline law is first reproduced and shown to degrade through cumulative adaptation-state growth, weakening of the Nussbaum modulation, and high internal command saturation. A hardware-oriented implementation is then evaluated that preserves the Nussbaum core while adding adaptation-state regularisation, low-speed velocity-reference feedforward, and tail-region damping; its parameters are selected through a hardware-aware Optuna archive of 79 real-hardware trials with hard rejection of unsafe runs and a score that jointly reflects tracking quality, internal command saturation, actuation activity, and bounded adaptation growth. Over 300 s of continuous operation, the enhanced implementation reduces the mean absolute error from to and the internal command saturation ratio from to relative to the direct baseline, within the reported actuator, trajectory, and safety envelope. The main contribution is therefore not only a tuned controller but a reproducible real-hardware methodology showing how Nussbaum-based PID control can be deployed and improved on a low-cost manipulator when adaptation management, actuation mapping, and hardware-aware optimisation are treated as core elements of the research design.
Real-hardware deployment of adaptive manipulator controllers remained difficult because assumptions made in paper-level formulations were often weakened by friction, encoder quantization, current limits, communication latency, and low-speed actuation nonlinearities. This paper investigated that deployment gap for a recent Nussbaum-function PID controller by translating it from a simulation-level formulation into direct current-command control on a Niryo NED3 Pro actuator. To isolate deployment-layer behaviour from whole-arm Coriolis, centrifugal, and gravity dynamics, the study focused on a single decoupled actuator (Dynamixel ID 6, distal wrist) under long-horizon sinusoidal tracking around a fixed operating region.A direct transfer of the baseline control law was first reproduced and was shown to degrade due to cumulative adaptation-state growth, weakening of the Nussbaum modulation, and high internal command saturation. A hardware-oriented implementation was then evaluated that preserved the Nussbaum core while introducing adaptation-state regularization, low-speed velocity-reference feedforward, and tail-region damping. Its parameters were selected through a hardware-aware Optuna optimization archive comprising 79 real-hardware trials, with unsafe runs rejected and a composite score reflecting tracking quality, internal command saturation, actuation activity, and bounded adaptation growth.Over 300 s of continuous operation, the enhanced implementation reduced the mean absolute error from 10.476° to 1.054° and the internal command saturation ratio from 0.450 to 0.012 relative to the direct baseline, within the reported actuator, trajectory, and safety envelope. The main contribution was therefore not only a tuned controller but also a reproducible real-hardware methodology demonstrating how Nussbaum-based PID control could be successfully deployed and improved on a low-cost manipulator when adaptation management, actuation mapping, and hardware-aware optimization were treated as integral elements of the research design.