This study examined the effect of 1.5% NaOCl, 17% EDTA, and curcumin on the proliferation, attachment, and differentiation of dental pulp stem cells (DPSCs) placed on the dentin specimens. MTT assay was performed to evaluate the proliferation of DPSCs on the dentin specimens treated with different concentrations of NaOCl, 17% EDTA, and curcumin (0.97-250 μM). Cell-adhering ability of DPSCs was tested via the LDH assay to calculate the attached DPSCs. In addition, the western blotting assay was performed to investigate the expression levels of fibronectin as a cell-adhesion marker and analyze the expressions level of differentiation markers, including DMP-1, OCN, ALP, and DSPP, to detect the odontogenic potential of hDPCs. NaOCl had lower toxicity on DPSCs at lower concentrations (P < 0.001). The cytotoxicity of irrigants increased with increased dosage. The difference between the cell-adhesion ability of NaOCl and curcumin was not significant (∼4.4 MU/mL), whereas EDTA (∼3.8 MU/mL) exhibited the lowest release of LDH and less damage to hDPSCs. Regarding fibronectin expression, the pattern differed between irrigants in inducing cell adhesion. NaOCl increased fibronectin expression more than EDTA and curcumin. All the treated groups upregulated the expression of DSPP, DMP-1, OCN, and ALP compared to the control group, in which NaOCl showed a higher effect on the overexpression of differentiation markers. The results showed that all the tested irrigants could be used in regenerative endodontic treatment. However, as an herbal-based and biocompatible irrigant, curcumin exhibited fewer adverse effects than NaOCl and EDTA.
Purpose: Using X-ray micro-computed tomography (micro-CT), the aim of this study was to measure the porosity of two tricalcium silicate sealers (EndoSequence BC and NeoSealer Flo) applied using three obturation techniques (single-cone, warm-vertical, and cold-lateral) to six single-rooted human teeth.Methods: Six extracted, single-rooted human teeth were shaped with ProTaper Next rotary files and obturated with EndoSequence BC or NeoSealer Flo sealers and gutta-percha (GP) using one of the three techniques above. Micro-CT was used to map the full length of the canals. Deep learning cross-sectional segmentation was used to analyze image slices of the apical (0-2 mm) and coronal (14-16 mm from the apex) regions (n = 230-261 per tooth) for the areas of GP and sealer, as well as porosity. Median (%) with interquartile range of porosity were calculated , and the results were statistically analyzed with the Kruskal-Wallis test.Results: In the apical region, EndoSequence BC had significantly fewer pores than NeoSealer Flo with the single-cone obturation (% median-interquartile range, IQR: 0.00-1.62) and warm-vertical condensation (5.57-10.32) techniques, whereas in the coronal region, NeoSealer Flo had significantly fewer pores than EndoSequence BC with these two techniques (0.39-5.02) and (0.10-0.19), respectively. There was no significant difference in porosity between the two sealers for the cold-lateral condensation technique in both the apical and coronal regions.Conclusion: For optimal obturation, the choice of technique and sealer is critical.