Yuh-Yih Wu

Yuh-Yih Wu

orcid

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 June 2006 in International Journal of Heat and Mass Transfer
Verified
Journal Article
Closed access
YWYuh-Yih Wu
Yuh-Yih Wu
BCBo-Chiuan Chen
Bo-Chiuan Chen
FHFeng-Chi Hsieh
Feng-Chi Hsieh

28 April 2019 in Energies
Verified
Journal Article
Open access
PDF file
JGJen Chiun Guan
Jen Chiun Guan
BCBo-Chiuan Chen
Bo-Chiuan Chen
YWYuh-Yih Wu
Yuh-Yih Wu
The cruising distance of the range extended electric vehicle (REEV) can be further extended using a range extender, which consists of an engine and a generator, i.e., a genset. An adaptive power management strategy (PMS) based on the equivalent fuel consumption minimization strategy (ECMS) is proposed for the REEV in this paper. The desired trajectory of the state of charge (SOC) is designed based on the energy-to-distance ratio, which is defined as the difference between the initial SOC and the minimum allowable SOC divided by the remaining travel distance, for discharging the battery. A self-organizing fuzzy controller (SOFC) with SOC feedback is utilized to modify the equivalence factor, which is defined as the fuel consumption rate per unit of electric power, for tracking the desired SOC trajectory. An instantaneous cost function, that consists of the fuel consumption rate of the genset and the equivalent fuel consumption rate of the battery, is minimized to find the optimum power distribution for the genset and the battery. Dynamic programming, which is a global minimization method, is employed to obtain the performance upper bound for the target REEV. Simulation results show that the proposed algorithm is adaptive for different driving cycles and can effectively increase the fuel economy of the thermostat control strategy (TCS) by 11.1% to 16%. The proposed algorithm can also reduce average charging/discharging powers and low SOC operations for possibly extending the battery life and increasing the battery efficiency, respectively. An experiment of the prototype REEV on a chassis dynamometer is set up with the proposed algorithm implemented on a real-time controller. Experiment results show that the proposed algorithm can increase the fuel economy of the TCS by 7.8% for the tested driving cycle. In addition, the proposed algorithm can reduce the average charge/discharge powers of TCS by 7.9% and 11.7%, respectively.

31 March 2009 in International Journal of Heat and Mass Transfer
Verified
Journal Article
Closed access
YWYuh-Yih Wu
Yuh-Yih Wu
BCBo-Chiuan Chen
Bo-Chiuan Chen
FHFeng-Chi Hsieh
Feng-Chi Hsieh
CKCheng-Ting Ke
Cheng-Ting Ke

1 November 2018 in Energies
Verified
Journal Article
Open access
PDF file
YWYuh-Yih Wu
Yuh-Yih Wu
JWJames H. Wang
James H. Wang
FMFaizan Mushtaq Mir
Faizan Mushtaq Mir
The efficiency of an internal combustion engine (ICE) is essential for automobiles and motorcycles. Several studies have demonstrated that the homogeneous charge compression ignition (HCCI) is a promising technology for realizing engines with high efficiency and low emissions. This study investigated the combustion characteristics of the HCCI using a 125 cc motorcycle engine with n-heptane fuel. The engine performance, combustion characteristics, and thermal efficiency were analyzed from experimental data. The results revealed that a leaner air–fuel mixture led to higher engine efficiency and output. The improvement of engine output is contradictory to the general trend. Energy balance analysis revealed that lower heat loss, due to the low cylinder gas temperature of lean combustion, contributed to higher efficiency. A double-Wiebe function provided excellent simulation of the mass fraction burned (MFB) of the HCCI. Air cycle simulation with the MFB, provided by the double-Wiebe function, was executed to investigate this phenomenon. The results indicated that a better combustion pattern led to higher thermal efficiency, and thus the engine output and thermal efficiency do not require a fast combustion rate in an HCCI engine. A better combustion pattern can be achieved by adjusting air–fuel ratio (AFR) and the rates of dual fuel and exhaust gas recirculation (EGR).

4 March 2019 in Energies
Verified
Journal Article
Open access
PDF file
YWYuh-Yih Wu
Yuh-Yih Wu
CJChing-Tzan Jang
Ching-Tzan Jang
Exhaust emissions from the large population of motorcycles are a major issue in Asian countries. The regulation of exhaust emissions is therefore becoming increasingly stringent, with those relating to nitrogen oxides (NOx) the most difficult to pass. The homogeneous charge compression ignition (HCCI) has special combustion characteristics and hence produces low NOx emissions and exhibits high thermal efficiency. This study developed an HCCI system for a 150 cc motorcycle engine. The target engine was modified using a dual-fuel of dimethyl ether (DME) and gasoline with exhaust gas recirculation (EGR). It was tested at 2000–4000 rpm and the analysis was focused on 2000 rpm. The DME was supplied continuously at an injection pressure of 1.5 kg/cm2. The gasoline injection rate was adjusted at a pressure of 2.5 kg/cm2. A brake-specific fuel consumption of <250 g/kW·h was achieved under a condition of air–fuel equivalence ratio (λ) < 2 and an EGR of 25%. The nitric oxide concentration was too low to measure. The brake mean effective pressure (BMEP) increased by 65.8% from 2.93 to 4.86 bar when the EGR was 0% to 25%. The combustion efficiency was close to 100% when the BMEP was >3 bar.

22 January 2010 in Journal of Engineering for Gas Turbines and Power
Verified
Journal Article
Closed access
PDF file
YWYuh-Yih Wu
Yuh-Yih Wu
CJChing-Tzan Jang
Ching-Tzan Jang
BCBo-Liang Chen
Bo-Liang Chen
Homogeneous charge compression ignition (HCCI) is recognized as an advanced combustion system for internal combustion engines that reduces fuel consumption and exhaust emissions. This work studied a 150 cc air-cooled, four-stroke motorcycle engine employing HCCI combustion. The compression ratio was increased from 10.5 to 12.4 by modifying the cylinder head. Kerosene fuel was used without intake air heating and operated at various excess air ratios (λ), engine speeds, and exhaust gas recirculation (EGR) rates. Combustion characteristics and emissions on the target engine were measured. It was found that keeping the cylinder head temperature at around 120–130°C is important for conducting a stable experiment. Two-stage ignition was observed from the heat release rate curve, which was calculated from cylinder pressure. Higher λ or EGR causes lower peak pressure, lower maximum rate of pressure rise (MRPR), and higher emission of CO. However, EGR is better than λ for decreasing the peak pressure and MRPR without deteriorating the engine output. Advancing the timing of peak pressure causes high peak pressure, and hence increases MRPR. The timing of peak pressure around 10–15 degree of crank angle after top dead center indicates a good appearance for low MRPR.