This paper presents a modeling framework for nonpoint source (NPS) pollution control which involves the use of the MapShed hydrological model and the Water Quality Analysis Simulation Program (WASP8) to identify critical source areas (CSAs) for improving in-stream water quality at the watershed scale based on the efficiencies of agricultural best management practices (BMPs) for NPS load reductions. The study area is the coastal watershed of the Lower Aksu Stream in the south of Turkey. Extensive data collection facilitated model calibration, validation, and scenario analyses. There was a good agreement between the model predictions and measurements related to flow rate and water quality parameters. The most effective scenario (S3) combining BMPs for agriculture, pastureland, and animal waste management achieved significant annual load reductions: approximately 40% for total nitrogen (TN) and 25% for total phosphorus (TP). Two sub-watersheds were defined as the CSAs based on the contributions to total NPS pollution loads and load reductions by the investigated BMPs. Pastureland and animal waste management practices (S1 Scenario) were most effective in sub-watershed 5 with contributions of approximately 32% for both TN and TP annual load reductions. Scenario S2 (agricultural waste management) and Scenario S3 were most successful in sub-watershed 8 with contributions of 30.3% and 27.3% for TN and 35.7% and 28.7% for TP annual load reductions, respectively. The identification of CSAs enhances the effectiveness of BMPs for NPS pollution control.
Efficient and sustainable management of urban water resources is challenged by increasing water demand and water losses in distribution networks. Developing a Standard Water Balance (SWB) at the District Metered Area (DMA) scale is an effective method for quantifying water losses and supporting Non-Revenue Water (NRW) reduction strategies. This study applies a monthly SWB to a pilot DMA in Antalya, Türkiye. System input volumes were obtained from SCADA-based flow measurements, while billed authorized consumption was calculated using customer billing records from the local water utility. The results show distinct monthly variations in system input volume, with higher water losses observed during periods of increased demand. These findings demonstrate that a monthly, DMA-based SWB is a practical decision-support tool for sustainable water loss management.
An EU-funded project was implemented to enhance efficiency and reliability in the water supply system of Antalya city in Türkiye to support climate change adaptation by reducing Non-Revenue Water (NRW). Extensive fieldwork and targeted actions of continuous Minimum Night Flow monitoring, Active Leakage Control, pressure management, and replacement of aging meters were applied to identify and reduce NRW. The project demonstrated that the commonly used percentage water loss indicator in Türkiye, the regulatory performance indicator, is biased and that the Infrastructure Leakage Index provides a more accurate performance measure. Training and experience-sharing workshops were conducted for district, provincial, and metropolitan municipalities in addition to an international regional conference, strengthening institutional capacity for sustainable water loss management. The project demonstrated that substantial gains in efficiency, reliability, and climate resilience can be achieved through integrated water loss management, advanced monitoring technologies, and performance-based evaluation frameworks.