We have investigated a novel gas/solid contacting configuration for chemical looping combustion (CLC) with potential operating benefits. CLC configurations are typically able to achieve high fuel conversion efficiencies at the expense of high operating costs and low system reliability. The spouted fluid bed (SB) was identified as an improved reactor configuration for CLC, since it typically exhibits high heat transfer rates and offers the ability to use lower gas flows for material movement compared to bubbling beds (BB). Multiphase Flow with Interphase eXchanges (MFIX) software was used to establish a spouted fluid bed reactor design. An experimental setup was built to supplement the model. The experimental setup was also modified for testing under high temperature, reacting conditions (1073–1273 K). The setup was operated in either a spouted fluid bed or a bubbling bed regime to compare the performance attributes of each. Results for the reactor configurations are presented for CLC using a mixture of carbon monoxide and hydrogen as fuel. Compared to the bubbling bed, the spouted fluid bed reactor achieved an equivalent or better fuel conversion at a lower pressure drop over the material bed. The spouted fluid bed design represents a viable configuration to improve gas/solid contacting for efficient fuel conversion, lower energy requirements for material movement and increase operational robustness for CLC. The research laid the groundwork for future research into a multi-phase reacting flow CLC system. The system will be developed from computational fluid dynamic modeling and pilot-scale testing to expedite the development of CLC technologies.
This study presents a comprehensive evaluation of sorbent injection to mitigate sodium emissions in a 250 MWe cyclone-fired boiler using lignite coal. Using historical boiler operational data, a computational fluid dynamics (CFD) model was validated and simulations were subsequently conducted to identify optimum sorbent injection locations for maximizing dispersion within the boiler cross-section and limiting sorbent temperatures to avoid deactivation. Data from the literature were used to guide sorbent injection rates and target sorbent particle sizes. Subsequent field demonstrations with the injection of a commercially available sorbent achieved a 60–80% reduction in the gas phase sodium, which was visually corroborated by reduced deposition on heat exchanger probes placed inside the boiler as well as by data on ash composition as a function of size. Furthermore, a diffusion-kinetic model, incorporating alkali vapor (NaOH) capture and subsequent sorbent deactivation, was developed and integrated into the CFD simulations as a post-processing tool and tested against the field demonstration data. Additional bench-scale testing was conducted with a range of sorbents as part of tool development for selecting from locally available sorbent sources. These bench-scale tests indicated a definite shift in the aerosol particle size distribution (PSD) toward a coarser range and depletion in the ultra-fine sizes, confirming the capture of vapor phase sodium species by the sorbents. Notably, in these tests, the sorbents remained effective even when they became molten, suggesting the potential for more convenient and cost-effective injection strategies.