Poly(ether ether ketone) nanocomposites containing vapour-grown carbon nanofibres (CNF) were produced using standard polymer processing techniques. At high shear rates no significant increase in resin viscosity was observed. Nevertheless, the addition of the CNFs results in a higher melt strength at 360°C. Electron microscopy confirmed the homogeneous dispersion and alignment of nanofibres in the polymer matrix. Evaluation of the mechanical composite properties revealed a linear increase in tensile stiffness and strength with nanofibre loading fractions up to 15 wt% whilst matrix ductility was maintained up to 10 wt%. An interpretation of the composite performance by short-fibre theory resulted in rather low intrinsic stiffness properties of the vapour-grown CNF. Differential scanning calorimetry was used to investigate crystallization kinetics and degree of crystallinity. The CNFs were found not to act as nucleating sites. Furthermore, unidirectional sliding tests against two different counterpart materials (100Cr6 martensitic bearing steel, X5CrNi18-10 austenitic stainless steel) were performed. The carbon nanofibres were found to reduce the wear rate of PEEK significantly.
29 September 2008 in Polymer Engineering & Science
Early diagnosis is vital for effective disease management, selection of appropriate treatment regimes, and surveillance and control of disease transmission. There is a growing need for point-of-need diagnostic platforms, such as lateral flow immunoassays (LFIAs), to reduce healthcare burdens, particularly in low-resource settings. However, LFIAs often suffer from inadequate sensitivity and exhibit limited dynamic ranges, leading to late-stage diagnosis or misdiagnosis. Here, we present a signal enhancement platform for use in both plate- and paper-based immunoassays, based on the formation of a coupled nanoparticle network. We demonstrate the coupling of an antigen-targeting detection probe with a secondary, catalytically active nanoparticle by utilizing secondary antibody interactions. Here, we show that signal enhancement is achieved through two functional mechanisms: network formation, facilitated by the secondary nanoparticle increasing the relative concentration of nanoparticles immobilized at the test zone; and the inclusion of catalytically active nanoparticles, which catalyze the oxidation of a chromogenic substrate at the test zone. Through this approach, we yielded a 40-fold improvement in the limit of detection (LOD) using 40 nm gold nanoparticle detection probes in spiked pooled human saliva. Further, the signal enhancement platform can be utilized alongside a range of detection probes, including gold nanoparticles, commonly employed for use in LFIAs. This work concludes by showcasing that the signal enhancement mechanism is compatible for use with complex sample matrices, such as human saliva.
4-(2-Nitrobenzoyl)isoxazoles are readily available from 3,5-disubstituted 4-iodoisoxazoles through iodine–lithium exchange and trapping with 2-nitrobenzaldeyde, followed by Jones oxidation of the obtained secondary alcohols. Reductive ring transformation by means of treatment with iron in acetic acid gives 2-substituted 3-acyl-4-quinolones. The mechanism of the cyclization reaction was elucidated by using appropriately substituted isoxazole building blocks and 2D NMR investigation of the products. In contrast, catalytic hydrogenation leaves the isoxazole ring untouched, whereas reduction with NaBH4/NiCl2 gives 2-substituted 3-acylquinolines in an unprecedented reductive ring transformation.