This paper presents a 4 × 4 multiple-input–multiple-output (MIMO) antenna array for ultra-wide band (UWB) applications with 5.5 GHz wireless local area network (WLAN) band rejection characteristics. The single UWB antenna element consists of modified patch antenna with partial ground plane. WLAN band has been rejected by etching a U-shaped slot in the antenna element. The antenna elements have been arranged in a planar geometry where each element is orthogonal to its adjacent element. A fan-shaped parasitic decoupler, that consists of four strip lines connected with a central square-shaped conductor, is placed among the antenna elements. The dimensions of the antenna array are 67 × 67 × 1.6 mm3. Full wave simulations and experiments have been conducted where measured peak gain and average isolation were 8.1 and −20 dB, respectively. The calculated envelop correction coefficient was less than 0.01.
18 May 2020 in Journal of Electromagnetic Waves and Applications
This paper presents a novel two-element multiple input multiple output (MIMO) reconfigurable antenna that can be switched among 600 MHz, 1.8, 2.4, 3.5, and 5.5 GHz bands. The proposed antenna consists of two semi-circular ring-shaped strip-lines and a rectangular slot on the top conducting layer of the substrate and a U-shaped slot, etched on the bottom side of the substrate. Frequency reconfigurable characteristics have been achieved using single pole four throw radio frequency micro-electro-mechanical system switch. The switch has been installed in the ground slot. The dimensions of the proposed MIMO antenna are 32 × 98 × 1 mm3. Measured isolation greater than 15 dB has been achieved in the operating bands. The calculated envelop correlation coefficient is less than 0.04 and the diversity gain in the operating bands is greater than 9.8 dB.
19 October 2020 in International Journal of Microwave and Wireless Technologies
The paper presents a 1 × 2 B-shaped antenna array for dual-band operation at 4 and 8 GHz. The antenna design consists of a rectangular patch with two annular-strip lines fabricated on the top layer and finite ground plane on the bottom layer. The array is formed by designing an optimum T-shaped microstrip line for impedance matching. The dimensions of the antenna array are 78 × 36 × 1.6 mm3. Full-wave simulations have been conducted and the measured results are in good consent with the simulated results. The measured impedance bandwidth (reference −10 dB) has been observed at 3.84–4.16 and 7.78–8.38 GHz. Measured peak gain and radiation efficiency at 4 and 8 GHz are 8.3, 9.4 dB and 82.5 and 81.2%, respectively.