This paper presents a 4 × 4 multiple-input–multiple-output (MIMO) antenna array for ultra-wide band (UWB) applications with 5.5 GHz wireless local area network (WLAN) band rejection characteristics. The single UWB antenna element consists of modified patch antenna with partial ground plane. WLAN band has been rejected by etching a U-shaped slot in the antenna element. The antenna elements have been arranged in a planar geometry where each element is orthogonal to its adjacent element. A fan-shaped parasitic decoupler, that consists of four strip lines connected with a central square-shaped conductor, is placed among the antenna elements. The dimensions of the antenna array are 67 × 67 × 1.6 mm3. Full wave simulations and experiments have been conducted where measured peak gain and average isolation were 8.1 and −20 dB, respectively. The calculated envelop correction coefficient was less than 0.01.
1 June 2012 in Plastics, Rubber and Composites: Macromolecular Engineering
This paper describes a singly-fed circularly polarized rectangular dielectric resonator antenna (RDRA) for MIMO and 5G Sub 6 GHz applications. Circular polarization was achieved for both ports using a novel-shaped conformal metal strip. To improve the isolation between the radiators, a “S” shaped defective ground plane structure (DGPS) was used. In order to authenticate the estimated findings, a prototype of the suggested radiator was built and tested experimentally. Over the desired band, i.e., 3.57–4.48 GHz, a fractional impedance bandwidth of roughly 36.63 percent (−10 dB as reference) was reached. Parallel axial ratio bandwidth of 28.33 percent is achieved, which is in conjunction with impedance matching bandwidth. Between the ports, isolation of −28 dB is achieved Gain and other far-field parameters are also calculated and found to be within their optimum limits
Improving the photon absorption in thin-film solar cells with plasmonic nanoparticles is essential for the realization of extremely efficient cells with substantial cost reduction. Here, a comprehensive study of solar energy enhancement in a cadmium telluride (CdTe) thin-film solar cell based on the simple design of a square array of plasmonic titanium nanoparticles, has been reported. The excitation of localized plasmons in the metallic nanostructures together with the antireflection coating (ARC) significantly enhances the absorption of photons in the active CdTe layer. The proposed structure attained super absorption with a mean absorbance of more than 97.27% covering a wide range from visible to near-infrared (i.e., from 300 nm to 1200 nm), presenting a 90% absorption bandwidth over 900 nm, and the peak absorption is up to 99.9%. For qualitative analysis, the photocurrent density is also estimated for AM 1.5 solar illumination (global tilt), whose value reaches 40.36 mA cm−2, indicating the highest value reported to date. The impact of nanoparticle dimensions, various metal materials, shapes, and random arrangement of nanoparticles on optical absorption are discussed in detail. Moreover, the angle insensitivity is essentially validated by examining the absorption performance with oblique incidences and it is found that the solar cell keeps high absorption efficiency even when the incidence angle is greater than 0°. Therefore, these findings suggest that the proposed broadband structure has good prospect in attaining high power conversion efficiency while reducing the device cost.
18 May 2020 in Journal of Electromagnetic Waves and Applications
This paper presents a novel two-element multiple input multiple output (MIMO) reconfigurable antenna that can be switched among 600 MHz, 1.8, 2.4, 3.5, and 5.5 GHz bands. The proposed antenna consists of two semi-circular ring-shaped strip-lines and a rectangular slot on the top conducting layer of the substrate and a U-shaped slot, etched on the bottom side of the substrate. Frequency reconfigurable characteristics have been achieved using single pole four throw radio frequency micro-electro-mechanical system switch. The switch has been installed in the ground slot. The dimensions of the proposed MIMO antenna are 32 × 98 × 1 mm3. Measured isolation greater than 15 dB has been achieved in the operating bands. The calculated envelop correlation coefficient is less than 0.04 and the diversity gain in the operating bands is greater than 9.8 dB.