Savaş Yağlıkçı

Dr. Savaş Yağlıkçı

Energy Systems Engineering, Ankara University, Ankara, Turkey (Türkiye)
orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 February 2019 in Environmental Technology
Verified
Journal Article
Closed access
Savaş YağlıkçıSavaş Yağlıkçı
Savaş Yağlıkçı
YGYavuz Gokce
Yavuz Gokce
EYEmine Yagmur
Emine Yagmur
ZAZeki Aktas
Zeki Aktas
The pore structure, high surface area and good conductivity are the key properties for the electrochemical double layer based supercapacitors. The activated carbons were produced from the waste tea, utilising microwave pretreatment with H3PO4 and activation at 450°C. Sodium thiosulfate pentahydrate (Na2S2O3·5H2O) was used as sulphur doping agent at 800°C to enhance conductivity of the activated carbons. Supercapacitor electrodes were prepared from both the activated carbon (WTAC) and sulphur doped activated carbon (WTAC-S) samples and the electrochemical performances were tested in the presence of 6 M KOH and 1 M H2SO4 as electrolytes. The activated carbon samples were characterised by Brunauer–Emmett–Teller (BET) surface area, Scanning Electron Microscopy/Energy Dispersive X-Ray Spectroscopy (SEM/EDS) and Fourier Transform Infrared Spectroscopy (FTIR) analysis techniques. The electrochemical performance analyses were performed by galvanostatic charge–discharge (GCD), cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS) methods. The specific capacitance values of the WTAC and WTAC-S samples under the 1 A g−1 current density were found to be 89.3, 144.7 F g−1 for KOH electrolyte and 73.8 and 101.9 F g−1 for H2SO4 electrolyte, respectively. The results show that the sulphur doping process enhances the electrochemical performance of activated carbon samples. GRAPHICAL ABSTRACT

1 April 2021 in Journal of Environmental Chemical Engineering
Verified
Journal Article
Closed access
Yavuz GokceYavuz Gokce
Yavuz Gokce
Savaş YağlıkçıSavaş Yağlıkçı
Savaş Yağlıkçı
EYEmine Yagmur
Emine Yagmur
ABAnthony Banford
Anthony Banford
ZAZeki Aktas
Zeki Aktas

6 March 2024 in Journal of Sol-Gel Science and Technology
Verified
Journal Article
Open access
PDF file
OKOzcan Koysuren
Ozcan Koysuren
Klodian DhoskaKlodian Dhoska
Klodian Dhoska
HKHafize Nagehan Koysuren
Hafize Nagehan Koysuren
IMIrida Markja
Irida Markja
Savaş YağlıkçıSavaş Yağlıkçı
Savaş Yağlıkçı
EBElena Bebi
Elena Bebi
The accumulation of pollution and any kinds of contamination on the glass cover of the solar cell affects the efficiency of the photovoltaic (PV) systems. The contamination on the glass cover can absorb and reflect a certain part of the sunlight irradiation, which can decrease the intensity of the light coming in through the glass cover. With the study, it was planned to develop self-cleaning coatings for the PV systems. It was aimed to prevent or reduce the contamination-induced efficiency loss of the existing PV systems. In the scope of the project, SiO2/WO3 and SiO2/WO3/ZnO composites were coated from their solutions on the glass substrates using a dip-coating technique. WO3 was selected as a photocatalyst semiconductor. Under the UV light irradiation, WO3 could absorb the photons of the UV light, generating the photoinduced charge carriers. The photoexcited charge carriers provide both the photoinduced hydrophilicity on the surface of the coating and the photocatalytic degradation of the organic contaminants accumulated on the surface of the coating, which allows water droplets to spread and flow on the surface of the cover glass to remove the contaminations. However, the recombination rate of the photoexcited charge carriers on the WO3 film was high. In order to suppress the recombination of the photoinduced charge carriers, WO3 was coupled with SiO2 and ZnO. Both of these semiconductors improved the photocatalytic activity of the WO3 film. Although SiO2 has superior features in terms of the light transmission, it was not very effective under UV light as a photocatalyst alone. The widely preferred photocatalyst ZnO was added into the composite film structure to enhance the photocatalytic activity. The self-cleaning mechanism of the film coatings on a solar cell was investigated through the photocatalytic dye removal efficiency on the as-prepared film samples. There was a slight decrease in the light transparency and the solar cell efficiency because of the WO3 content of the composite film. On the other hand, coupling the SiO2/WO3 film with ZnO enhanced the photocatalytic activity, and it suppressed the reduction effect of the WO3 phase on both the light transparency and the solar cell efficiency. The photocatalytic dye removal efficiency was increased to over 90% after 240 min of UVA light irradiation. In addition, the solar cell coated with the SiO2/WO3/ZnO film provided almost the same solar cell efficiency as the uncoated solar cell. The water contact angle measurement also exhibited the photocatalytic degradation of the model contamination on the glass cover of the solar cell under the UVA light irradiation. Graphical Abstract

22 September 2021 in Journal of Wood Chemistry and Technology
Verified
Journal Article
Closed access
NHNAZIFE ISIK HAYKIR
NAZIFE ISIK HAYKIR
KSKaan Soysal
Kaan Soysal
Savaş YağlıkçıSavaş Yağlıkçı
Savaş Yağlıkçı
YGYavuz Gokce
Yavuz Gokce
In this study, pine (Pinus radiata) pretreated with PIL, triethylammonium hydrogen sulfate (TEAHSO4) at different water-PIL ratios (1:9, 1:4 and 3:7), biomass loadings (10–60%) and biomass particle sizes (<1.18 mm, 1.18–1.76 mm and 1.76–2.40 mm) was enzymatically transformed into fermentable sugars. TEAHSO4 removed 52% lignin with pretreatment at 170 °C, 20% loading and 1:4 water-PIL ratio for 3 h, from biomass with the largest particle size. Reducing the water content of PIL solution enhanced delignification performance of PIL under the same conditions; cellulose content of the biomass increased 2-fold by extracting 59% lignin from pine. Compositional changes were supported with saccharification and characterization analyses. Utilizing 1:4 water-PIL ratio introduced more constructive pretreatment conditions with respect to the changes in lignin particle size distribution. Attaining favorable compositional changes for pine as a recalcitrant softwood motivated the contribution of PILs to IL based biorefineries.

1 February 2021 in Surfaces and Interfaces
Verified
Journal Article
Closed access
Savaş YağlıkçıSavaş Yağlıkçı
Savaş Yağlıkçı
Yavuz GokceYavuz Gokce
Yavuz Gokce
EYEmine Yagmur
Emine Yagmur
ABAnthony Banford
Anthony Banford
ZAZeki Aktas
Zeki Aktas

6 November 2023 in Journal of Industrial and Engineering Chemistry
Verified
Journal Article
Closed access
YGYavuz Gokce
Yavuz Gokce
EYEmine Yagmur
Emine Yagmur
Savaş YağlıkçıSavaş Yağlıkçı
Savaş Yağlıkçı
ABAnthony Banford
Anthony Banford
ZAZeki Aktas
Zeki Aktas