Bioelectronics needs to continuously monitor mechanical and electrophysiological signals for patients. However, the signals always include artifacts by patients’ unexpected movement (such as walking and respiration under approximately 30 hertz). The current method to remove them is a signal process that uses a bandpass filter, which may cause signal loss. We present an unconventional bandpass filter material—viscoelastic gelatin-chitosan hydrogel damper, inspired by the viscoelastic cuticular pad in a spider—to remove dynamic mechanical noise artifacts selectively. The hydrogel exhibits frequency-dependent phase transition that results in a rubbery state that damps low-frequency noise and a glassy state that transmits the desired high-frequency signals. It serves as an adaptable passfilter that enables the acquisition of high-quality signals from patients while minimizing signal process for advanced bioelectronics.

Environmental and health concerns force the search for sustainable super engineering plastics (SEPs) that utilise bio-derived cyclic monomers, e.g. isosorbide instead of restricted petrochemicals. However, previously reported bio-derived thermosets or thermoplastics rarely offer thermal/mechanical properties, scalability, or recycling that match those of petrochemical SEPs. Here we use a phase transfer catalyst to synthesise an isosorbide-based polymer with a high molecular weight >100 kg mol⁻¹, which is reproducible at a 1-kg-scale production. It is transparent and solvent/melt-processible for recycling, with a glass transition temperature of 212 °C, a tensile strength of 78 MPa, and a thermal expansion coefficient of 23.8 ppm K⁻¹. Such a performance combination has not been reported before for bio-based thermoplastics, petrochemical SEPs, or thermosets. Interestingly, quantum chemical simulations show the alicyclic bicyclic ring structure of isosorbide imposes stronger geometric restraint to polymer chain than the aromatic group of bisphenol-A.

As one of conducting polymers, PEDOT:PSS, is commonly used in organic electronics, especially for bioelectronics due to its advantages such as high electrical and ionic conductivity, solution-processability and biocompatibility. Creating bioelectronics with the PEDOT:PSS requires advanced techniques to obtain physical/chemical modification of the PEDOT:PSS for improved performance and various applications. To satisfy these demands, fibrillary gelation of PEDOT:PSS by injection to choline acetate, an ionic liquid, with a constant flow rate was used in this study to make a conductive fiber and improve characteristics of PEDOT:PSS. Conductive fibers by fibrillary gelation showed enhanced electrical conductivity of about 400 S cm⁻¹ and volumetric capacitance of about 154 F cm⁻³ which would be strongly beneficial to be utilized for organic electrochemical transistors (OECTs), resulting in a high transconductance of 19 mS in a depletion-mode. Moreover, dedoping of the conductive fibers by PEI (polyethyleneimine) enabled the creation of enhancement-mode OECTs. Interdigitated inverters were then fabricated by connecting depletion and enhancement-mode OECTs. These results demonstrate that these conductive fibers and electronic-textiles are suitable candidates for applications in bio-integrated electronics.