The 2014–2015 Bárðarbunga‐Veiðivötn fissure eruption at Holuhraun produced about 1.5 km³ of lava, making it the largest eruption in Iceland in more than 200 years. Over the course of the eruption, daily volcanic sulfur dioxide (SO₂) emissions exceeded daily SO₂ emissions from all anthropogenic sources in Europe in 2010 by at least a factor of 3. We present surface air quality observations from across Northern Europe together with satellite remote sensing data and model simulations of volcanic SO₂ for September 2014. We show that volcanic SO₂ was transported in the lowermost troposphere over long distances and detected by air quality monitoring stations up to 2750 km away from the source. Using retrievals from the Ozone Monitoring Instrument (OMI) and the Infrared Atmospheric Sounding Interferometer (IASI), we calculate an average daily SO₂ mass burden of 99 ± 49 kilotons (kt) of SO₂ from OMI and 61 ± 18 kt of SO₂ from IASI for September 2014. This volcanic burden is at least a factor of 2 greater than the average SO₂ mass burden between 2007 and 2009 due to anthropogenic emissions from the whole of Europe. Combining the observational data with model simulations using the United Kingdom Met Office's Numerical Atmospheric‐dispersion Modelling Environment model, we are able to constrain SO₂ emission rates to up to 120 kilotons per day (kt/d) during early September 2014, followed by a decrease to 20–60 kt/d between 6 and 22 September 2014, followed by a renewed increase to 60–120 kt/d until the end of September 2014. Based on these fluxes, we estimate that the eruption emitted a total of 2.0 ± 0.6 Tg of SO₂ during September 2014, in good agreement with ground‐based remote sensing and petrological estimates. Although satellite‐derived and model‐simulated vertical column densities of SO₂ agree well, the model simulations are biased low by up to a factor of 8 when compared to surface observations of volcanic SO₂ on 6–7 September 2014 in Ireland. These biases are mainly due to relatively small horizontal and vertical positional errors in the simulations of the volcanic plume occurring over transport distances of thousands of kilometers. Although the volcanic air pollution episodes were transient and lava‐dominated volcanic eruptions are sporadic events, the observations suggest that (i) during an eruption, volcanic SO₂ measurements should be assimilated for near real‐time air quality forecasting and (ii) existing air quality monitoring networks should be retained or extended to monitor SO₂ and other volcanic pollutants.

Volcanic air pollution from both explosive and effusive activity can affect large populations as far as thousands of kilometers away from the source, for days to decades or even centuries. Here, we summarize key advances and prospects in the assessment of health hazards, effects, risk, and management. Recent advances include standardized ash assessment methods to characterize the multiple physicochemical characteristics that might influence toxicity; the rise of community-based air quality monitoring networks using low-cost gas and particulate sensors; the development of forecasting methods for ground-level concentrations and associated public advisories; the development of risk and impact assessment methods to explore health consequences of future eruptions; and the development of evidence-based, locally specific measures for health protection. However, it remains problematic that the health effects of many major and sometimes long-duration eruptions near large populations have gone completely unmonitored. Similarly, effects of prolonged degassing on exposed populations have received very little attention relative to explosive eruptions. Furthermore, very few studies have longitudinally followed populations chronically exposed to volcanic emissions; thus, knowledge gaps remain about whether chronic exposures can trigger development of potentially fatal diseases. Instigating such studies will be facilitated by continued co-development of standardized protocols, supporting local study teams and procuring equipment, funding, and ethical permissions. Relationship building between visiting researchers and host country academic, observatory, and agency partners is vital and can, in turn, support the effective communication of health impacts of volcanic air pollution to populations, health practitioners, and emergency managers.

There is considerable interest in using low-cost optical particle counters (OPCs) to supplement existing routine air quality networks that monitor particle mass concentrations. In order to do this, low-cost OPC data need to be comparable with particle mass reference instrumentation; however, there is currently no widely agreed upon methodology to accomplish this. Aerosol hygroscopicity is known to be a key parameter to consider when correcting particle mass concentrations derived from low-cost OPCs, particularly at high ambient relative humidity (RH). Correction factors have been developed that apply κ-Köhler theory to correct for the influence of water uptake by hygroscopic aerosols. We have used datasets of co-located reference particle measurements and low-cost OPC (OPC-N2, Alphasense) measurements, collected in four cities on three continents, to explore the performance of this correction factor. We provide evidence that the elevated particle mass concentrations, reported by the low-cost OPC relative to reference instrumentation, are due to bulk aerosol hygroscopicity under different RH conditions, which is determined by aerosol composition and, in particular, the levels of hygroscopic aerosols (sulfate and nitrate). We exploit measurements made in volcanic plumes in Nicaragua, which are predominantly composed of sulfate aerosol, as a natural experiment to demonstrate this behaviour in the ambient atmosphere; the observed humidogram from these measurements closely resembles the calculated pure sulfuric acid humidogram. The results indicate that the particle mass concentrations derived from low-cost OPCs during periods of high RH (>60 %) need to be corrected for aerosol hygroscopic growth. We employed a correction factor based on κ-Köhler theory and observed that the corrected OPC-N2 PM_2.5 mass concentrations were within 33 % of reference measurements at all sites. The results indicated that a κ value derived in situ (using suitable reference instrumentation) would lead to the most accurate correction relative to co-located reference instruments. Applying a κ values from the literature in the correction factor also resulted in improved OPC-N2 performance, with the measurements being within 50 % of the reference values. Therefore, for areas where suitable reference instrumentation for developing a local correction factor is lacking, using a literature κ value can result in a reasonable correction. For locations with low levels of hygroscopic aerosols and low RH values, a simple calibration against gravimetric measurements (using suitable reference instrumentation) would likely be sufficient. Whilst this study generated correction factors specific for the Alphasense OPC-N2 sensor, the calibration methodology developed is likely amenable to other low-cost PM sensors.

The 2014-2015 Holuhraun eruption in Iceland, emitted ~11 Tg of SO2 into the troposphere over 6 months, and caused one of the most intense and widespread volcanogenic air pollution events in centuries. This study provides a number of source terms for characterisation of plumes in large fissure eruptions, in Iceland and elsewhere. We characterised the chemistry of aerosol particle matter (PM) and gas in the Holuhraun plume, and its evolution as the plume dispersed, both via measurements and modelling. The plume was sampled at the eruptive vent, and in two populated areas in Iceland. The plume caused repeated air pollution events, exceeding hourly air quality standards (350 μg/m3) for SO2 on 88 occasions in Reykjahlíð town (100 km distance), and 34 occasions in Reykjavík capital area (250 km distance). Average daily concentration of volcanogenic PM sulphate exceeded 5 μg/m3 on 30 days in Reykjavík capital area, which is the maximum concentration measured during non-eruptive background interval. There are currently no established air quality standards for sulphate. Combining the results from direct sampling and dispersion modelling, we identified two types of plume impacting the downwind populated areas. The first type was characterised by high concentrations of both SO2 and S-bearing PM, with a high Sgas/SPM mass ratio (SO2(g)/SO42-(PM) >10). The second type had a low Sgas/SPM ratio (<10). We suggest that this second type was a mature plume where sulphur had undergone significant gas-to-aerosol conversion in the atmosphere. Both types of plume were rich in fine aerosol (predominantly PM1 and PM2.5), sulphate (on average ~90% of the PM mass) and various trace species, including heavy metals. The fine size of the volcanic PM mass (75-80% in PM2.5), and the high environmental lability of its chemical components have potential adverse implications for environmental and health impacts. However, only the dispersion of volcanic SO2 was forecast in public warnings and operationally 47 monitored during the eruption. We make a recommendation that sulphur gas-to-aerosol conversion processes, and a sufficiently large model domain to contain the transport of a tropospheric plume on the timescale of days be utilized for public health and environmental impact forecasting in future eruptions in Iceland and elsewhere in the world

Recent Icelandic rifting events have illuminated the roles of centralized crustal magma reservoirs and lateral magma transport^1–4, important characteristics of mid-ocean ridge magmatism^1,5. A consequence of such shallow crustal processing of magmas^4,5 is the overprinting of signatures that trace the origin, evolution and transport of melts in the uppermost mantle and lowermost crust^6,7. Here we present unique insights into processes occurring in this zone from integrated petrologic and geochemical studies of the 2021 Fagradalsfjall eruption on the Reykjanes Peninsula in Iceland. Geochemical analyses of basalts erupted during the first 50 days of the eruption, combined with associated gas emissions, reveal direct sourcing from a near-Moho magma storage zone. Geochemical proxies, which signify different mantle compositions and melting conditions, changed at a rate unparalleled for individual basaltic eruptions globally. Initially, the erupted lava was dominated by melts sourced from the shallowest mantle but over the following three weeks became increasingly dominated by magmas generated at a greater depth. This exceptionally rapid trend in erupted compositions provides an unprecedented temporal record of magma mixing that filters the mantle signal, consistent with processing in near-Moho melt lenses containing 10⁷–10⁸ m³ of basaltic magma. Exposing previously inaccessible parts of this key magma processing zone to near-real-time investigations provides new insights into the timescales and operational mode of basaltic magma systems.