Electrochemical impedance spectroscopy (EIS) resolves the internal physicochemical processes of lithium-ion batteries across timescales—from ohmic conduction through charge-transfer kinetics to solid-state diffusion. Despite this analytical power, EIS deployment remains largely confined to laboratory electrochemical workstations that are bulky, expensive, and incapable of online multi-cell operation under dynamic DC bias conditions. This study presents a multi-channel EIS measurement device that simultaneously addresses three requirements for practical battery diagnostics: workstation-grade measurement accuracy, multi-cell synchronous acquisition, and tolerance to the DC bias voltage present across battery terminals during operation. The device employs a master–slave distributed architecture: each slave unit is built around the DNB1101 battery-dedicated impedance measurement chip with a Kelvin four-wire sensing configuration, while the STM32F407-based master controller coordinates measurement scheduling and data communication under FreeRTOS. A four-channel slave board with a differential daisy-chain communication topology and hardware broadcast trigger mechanism supports multi-cell synchronous acquisition. The device operates over a frequency range of 0.01 Hz to 5620 Hz with logarithmic spacing, and a C#-based host application provides real-time Nyquist and Bode visualization along with MATLAB R2024a-based post-processing for outlier rejection and data smoothing. Validation was conducted using Panasonic NCR18650 ternary (NCA) and LiFePO4 (LFP) 18650 cells, benchmarked against a CorrTest CS350 electrochemical workstation at SOC = 40% and 25 °C. The device achieves a maximum impedance magnitude error of 1.55% and a maximum phase error of 1.22%. Equivalent circuit model fitting via ZSimpWin yields parameter differences below 1% between the device and the reference workstation. Under online conditions with a 3.6 V DC bias, the impedance measurement deviation of a 20 mΩ precision resistor remains below 0.69% across the full frequency range. Multi-channel synchronous measurements across four cells demonstrate inter-channel amplitude variance below 2.13%. Cross-chemistry validation with LiFePO4 cells yields magnitude and phase errors below 0.92%. These results demonstrate that the proposed device provides laboratory-grade EIS accuracy with multi-channel, online, and cross-chemistry capabilities, offering a practical platform for integrating EIS-based diagnostics into next-generation battery management systems.
Neutron Depth Profiling (NDP) is a non‐destructive, in situ quantitative depth‐analysis technique underpinned by neutron‐induced nuclear reactions. Offering high 6 Li‐isotope sensitivity and nanometer‐to‐micrometer depth resolution, NDP delivers isotope‐resolved lithium spatial information hardly accessible via conventional probes including secondary‐ion mass spectrometry (SIMS), X‐ray photoelectron spectroscopy (XPS), and operando neutron imaging, yet it suffers from depth‐dependent resolution degradation, limited lateral performance, and requires large‐scale neutron‐beam facilities. This paper systematically reviews NDP fundamentals, global neutron‐source progress, and cutting‐edge battery applications, covering lithium‐ion migration in electrodes, lithium dendrite nucleation and growth, and the “reversible short‐circuit” effect at solid‐electrolyte interfaces. The unique merit of NDP for quantitative 6 Li depth‐profiling is highlighted, while noting that NDP cannot independently resolve full‐element maps or nanoscale interfaces and demands complementary characterizations. A roadmap integrating NDP with multimodal measurements and physics‐informed machine learning for intelligent battery design is outlined, alongside open challenges: inversion non‐uniqueness under low‐signal conditions and translation from model cells to practical batteries. This work provides actionable guidelines to leverage NDP for bridging microscopic lithium mechanisms and rational design of next‑generation batteries with high safety and high energy density.