The development of simple and efficient analytical methods is fundamental for controlling the levels of toxic metals in liquid samples. In the present study, it is proposed the fabrication of a microstructured substrate based on filter paper, using in situ growth method of silver nanoparticles (AgNPs) into silver microparticles (AgMPs) to enhance the LIBS emission signal in the determination of Cu(II) in different liquid samples. Initially, ascorbic acid, NaBH4 and SnCl2 were evaluated as reducing agents for Ag particle formation. An 8-fold improvement in the copper signal was obtained when SnCl2 was used. The Ag particles obtained with the latter reducing agent were further grown, and the signal was enhanced up to 14-fold compared to the traditional LIBS method using unmodified filter paper. UV-Vis diffuse reflectance spectroscopy, X-ray diffraction measurements, and scanning electron microscopy (SEM) indicated efficient immobilization of both Ag nano- and microparticles on the microfibers of substrate. A calibration analytical curve for Cu(II) ions was obtained with a coefficient of determination (R2) of 0.99, a linear response from 0.2 to 1.0 mg L-1, and LOD and LOQ of 34 and 114 μg L-1, respectively. The signal enhancement achieved with the microstructured substrate fabricated using the in situ growth method can be attributed to the synergistic effect of the nanostructures present in the cellulosic microfibers and the surface enhancement caused by the dense layer of Ag microparticles. The developed analytical strategy was successfully applied to the determination of Cu(II) ions in fortified samples of river water, artificial urine, tea infusion, and canned tea, providing recoveries ranging from 85 to 112 %. These results indicate the effectiveness of a microstructured silver substrate for sensitive detection of metal ions at low concentrations in liquid samples.
Although the modification of resin composites with antimicrobial agents represents a viable alternative for biofilm inhibition, these changes may compromise the optical and mechanical properties of dental restorations. This in vitro pilot study evaluated the effect of incorporating Nano-Silver Fluoride (NSF) containing 2000 ppm silver nanoparticles (AgNPs) on the microhardness and color of flowable resin composites: Vittra APS Unique Flowable (VA), Filtek Bulk Fill Flowable (FB), and Filtek Supreme Flowable (FS). The resin composites were modified by adding 1 wt%, 2 wt%, and 4 wt% NSF and compared with an unmodified group (control). NSF was characterized by UV–visible spectroscopy and transmission electron microscopy. The specimens were subjected to Vickers microhardness testing and color analysis using the CIEDE2000 (ΔE00) and CIELAB (ΔE) systems. NSF incorporation had a material-dependent effect on microhardness. The VA group showed a progressive reduction in microhardness with increasing NSF additions, whereas the FS group remained unchanged up to the concentration of 2 wt%, and the FB group showed no significant reduction in microhardness at any of the tested concentrations compared with the control (p = 0.549). All resin composites exhibited clinically relevant color changes that increased with the NSF concentration, with more pronounced color changes in the VA group, whereas FB and FS did not vary significantly with the addition of different NSF concentrations. Overall, NSF mainly affected the optical properties, with esthetic limitations being the main challenge to be overcome in further studies. The FB and FS groups at 1 wt% and 2 wt% showed smaller chromatic changes than VA, without compromising microhardness, and appear promising for future investigations, including antimicrobial and cytotoxicity analyses.