Carlson trophic state index (CTSI) has been commonly adopted to assess the eutrophication potential of reservoirs or lakes in water quality management. This study aims to analyze the influential factors of CTSI-based eutrophication by using Pearson correlation analysis and principal component analysis with long-term data from 2008 to 2019 on 21 drinking water reservoirs in Taiwan. The trophic state index (TSI) deviation indicates that most drinking water reservoirs, around 45.5% of statistical data fall within non-algal turbidity with surplus phosphorus, especially in the spring and winter season. Besides, about 78% of total collected data show that TSI chlorophyll-a (Chl-a) is less than TSI Secchi depth (SD) due to the small particulate predominance. On the other hand, three TSI variables (SD, total phosphorus (TP) and Chl-a) of CTSI exhibits insignificant correlation to each other in most cases. Under such conditions, the probability of eutrophication (TSI > 50) based on TSI (SD) is 63%, while it is low as 20% based on TSI (TP) and TSI (Chl-a). The influencing factors of eutrophication variables by suspended solids (SS) composition and turbidity have shown that the SD is strongly influenced by non-algal SS. The deviations of three TSI have shown that the highest algae-induced eutrophication potential occurs in summer season. In addition, the TP is the most significant loading factor of algae-induced eutrophication for drinking water reservoirs. It is concluded that the CTSI has limited applicability to identify the trophic state of drinking water reservoirs in Taiwan in the presence of sustainable non-algal turbidity comparative Chl-a that specifically represents the potential of algal growth.
Low impact development (LID) is a relatively new concept in land use management that aims to maintain hydrological conditions at a predevelopment level without deteriorating water quality during land development. The United States Environmental Protection Agency (USEPA) developed the System for Urban Stormwater Treatment and Analysis Integration model (SUSTAIN) to evaluate the performance of LID practices at different spatial scales; however, the application of this model has been limited relative to LID modeling. In this study, the SUSTAIN model was applied to a Taiwanese watershed. Model calibration and verification were performed, and different types of LID facilities were evaluated. The model simulation process and the verified model parameters could be used in other cases. Four LID scenarios combining bioretention ponds, grass swales, and pervious pavements were designed based on the land characteristics. For the SUSTAIN model simulation, the results showed that pollution reduction was mainly due to water quantity reduction, infiltration was the dominant mechanism and plant interception had a minor effect on the treatment. The simulation results were used to rank the primary areas for nonpoint source pollution and identify effective LID practices. In addition to the case study, a sensitivity analysis of the model parameters was performed, showing that the soil infiltration rate was the most sensitive parameter affecting the LID performance. The objectives of the study are to confirm the applicability of the SUSTAIN model and to assess the effectiveness of LID practices in the studied watershed.
1 July 2003 in Journal of Environmental Science and Health, Part A
This study evaluates the feasibility of the treatment of textile effluents by H2O2/UV oxidation combined with reverse osmosis (RO) membrane separation for water reuse in textile dying processes. Th...
This article evaluates the H2O2/UV process for the removal of color and dissolved organic carbon (DOC) from textile effluent samples in a batch UV photoreactor. Experimental variables studied include pH, hydrogen peroxide dosage, oxidation time, and UV intensity. Results show that the H2O2/UV process showed better removal of DOC and color at pH 4 than at pH 7, suggesting that the pH should be controlled at both 4 and 7 for color removal, whereas only at 4 for DOC removal. Oxidation time was extended to 30 and 60 min, respectively, which resulted in removal of more than 70% of the color and DOC. Color and DOC removal followed pseudo first-order kinetics and the reaction rate constants increased with increasing both H2O2 dosage and UV intensity. Increase of H2O2 dosage is more efficient than the increase of UV intensity for promoting the treatment performance of the H2O2/UV process. Further, about 80% of DOC with a high molecular weight (MW) fraction was oxidized into DOC with medium and low MW fractions. DOC with low MW fractions predominated more than 60% of the residual DOC. Therefore, the oxidation of DOC with a high MW fraction into medium and low MW fractions was more important than the mineralization of DOC by H2O2/UV oxidation.
30 August 2022 in Journal of Water Supply: Research and Technology—AQUA
HIGHLIGHTS. Microcystis aeruginosa is most effectively removed by Al-based ECF at pH 8 for 5 mA/cm2.Bound EOM excretes significantly by EC but markedly reduces