With an elevation of 1000 m above sea level, once the coastal mountain range is crossed, the Atacama Desert receives the highest levels of solar radiation in the world. Global horizontal irradiations over 2500 kWh/(m2 year) and a cloudiness index below 3% were determined. However, this index rises to 45% in the coastal area, where the influence of the Pacific Ocean exists with a large presence of marine aerosols. It is on the coastal area that residential photovoltaic (PV) applications are concentrated. This work presents a study of the soiling impact on PV modules at the coastline of Atacama Desert. The current–voltage characteristics of two multicrystalline PV modules exposed to outdoor conditions were compared, while one of them was cleaned daily. Asymptotic behavior was observed in the accumulated surface dust density, over 6 months. This behavior was explained by the fact that as the glass became soiled, the probability of glass-to-particle interaction decreased in favor of a more likely particle-to-particle interaction. The surface dust density was at most 0.17 mg·cm−2 per month. Dust on the module led to current losses in the range of 19% after four months, which in turn produced a reduction of 13.5%rel in efficiency.
Moisture plays a critical role in the degradation process of photovoltaic (PV) modules in field conditions. A commonly used approach is to evaluate the properties of PV materials by conducting tests in climatic chambers, and then apply the Fickian diffusion model in simulations to replicate field conditions, however, without experimental verification. This study describes an experimental setup for in situ measurement of moisture in fielded minimodules, using miniature temperature and humidity sensors encapsulated within the modules. Five identical setups are deployed in different climatic regions around the world, enabling a quantitative evaluation of moisture diffusion in the field and a comparison of different climates. The relative humidity measured beside the cell follow weekly weather trends due to breathable backsheet, whereas the sensors in front of the cell react much slower to outside changes and follow seasonal trends. We show that a single 2-D simulation, which is a standard practice in published studies, is insufficient to accurately depict moisture diffusion in front of the cell. Therefore, a two-stage 2-D simulation model, combining Fickian diffusion in vertical and horizontal cross section with carefully set boundary conditions, was introduced. A comparison with measurement results showed the simulation approach to be a good compromise between the simulation accuracy and speed. Finally, the results underscore the significance of understanding the local microclimate surrounding the modules, including the interface between air and backsheet, which is necessary for precise moisture diffusion simulations.
Excess energy derived from photosynthesis can be used in plant microbial fuel cell (PMFC) systems as a sustainable alternative for the generation of electricity. In this study, the in situ performance of CAM (Crassulacean acid metabolism) plants in Calama, in the Atacama Desert, was evaluated for energy recovery using PMFCs with stainless steel AISI 316L and Cu as electrodes. The plant species evaluated included Aloe perfoliata, Cereus jamacaru, Austrocylindropuntia subulata, Agave potatorum, Aloe arborescens, Malephora crocea, and Kalanchoe daigremontiana. Among the plant species, Kalanchoe daigremontiana demonstrated significant potential as an in situ PMFC, showing a maximum cell potential of 0.248 V and a minimum of 0.139 V. In addition, the cumulative energy for recovery was about 9.4 mWh m−2 of the electrode. The use of CAM plants in PMFCs presents a novel approach for green energy generation, as these plants possess an inherent ability to adapt to arid environments and water-scarce areas such as the Atacama Desert climate.