A DMSO-incorporated low-dimensional BA–Pb–I hybrid crystal with a 1D Pb–I ribbon motif is formed by room-temperature mixed-solvent crystallization and exhibits excitonic emission with reduced phonon-induced linewidth broadening.
Two-dimensional (2D) organic–inorganic hybrid perovskites exhibit coupled ionic, electronic, and electromechanical responses that can strongly influence local charge transport. Here, solution-processed mixed-halide butylammonium lead perovskite crystals were mechanically exfoliated and investigated using X-ray diffraction, atomic force microscopy, piezoresponse force microscopy (PFM), and conductive atomic force microscopy (c-AFM). PFM measurements under −5, 0, and +5 V revealed clear bias-dependent changes in amplitude and phase, indicating an electric field-sensitive local electromechanical response. Local c-AFM measurements showed nonlinear bipolar hysteresis, with a pronounced increase in current near +7–8 V and a decrease near −7 to −6 V during the subsequent negative sweep. Because the crystals are mixed ionic–electronic conductors and the nanoscale tip–sample junction introduces substantial injection and contact barriers, the observed behavior is interpreted as resistive switching-like conductivity modulation, rather than definitive ferroelectric switching. The results are consistent with the combined contributions of charge injection, trap filling, possible ionic redistribution, and piezoelectricity-associated modulation of the local transport barrier. These findings provide nanoscale insight into electric field-dependent electromechanical and out-of-plane conductive behaviors in layered 2D hybrid perovskites.
Water-induced electrical responses were investigated using porous electrospun PAN-based composite membranes containing CNTs and CNCs. Following the injection of 20 μL of a 2 wt% NaCl solution, transient open-circuit voltage responses were observed from the PAN, PAN–CNT, and PAN–CNT–CNC devices, with maximum values of approximately 47, 42, and 68 mV, respectively, in the tested devices. Three successive injection–drying cycles demonstrated repeated transient responses within individual devices but did not establish device-to-device reproducibility or long-term stability. Raman and FTIR analyses supported the incorporation of CNTs and the modification of the water-interacting environment following CNC addition, respectively. The voltage waveform depended on the liquid type, NaCl concentration, and wetting–drying history, including a transient reverse-voltage response during drying. These results provide a proof-of-concept observation of wetting–drying-dependent electrical behavior in electrospun PAN-based porous membranes. Load-dependent power, long-term durability, and device-to-device reproducibility remain to be established.