A continuous-wave diamond Raman laser is demonstrated with an output power of 5.1 W at 1217 nm. This Raman laser is intracavity pumped by a side-pumped Nd:YLF rod laser: a 43-fold brightness enhancement between the Nd:YLF and diamond Raman lasers is observed, with the M2 beam propagation factor of the diamond Raman laser measured to be <; 1.2. Although higher output powers are demonstrated in a similar configuration using KGd(WO4)2 (KGW) as the Raman laser material (6.1 W), the brightness enhancement is much lower (2.5 fold) due to the poorer beam quality of the KGW Raman laser (M2 <; 6). The Raman gain coefficient of single-crystal synthetic diamond at a pump wavelength of 1064-nm is also measured: a maximum value of 21±2 cm/GW is returned compared to 5.7±0.5 cm/GW for KGW at the same wavelength.
In this paper, we analyse the prospects for using nitrogen-vacancy centre (NV) containing diamond as a laser gain material by measuring its key laser related parameters. Synthetic chemical vapour deposition grown diamond samples with an NV concentration of ~1 ppm have been selected because of their relatively high NV concentration and low background absorption in comparison to other samples available to us. For the samples measured, the luminescence lifetimes of the NV- and NV0 centres were measured to be 8 ± 1 ns and 20 ± 1 ns, respectively. The respective peak stimulated emission cross-sections were (3.6 ± 0.1) × 10−17 cm2 and (1.7 ± 0.1) × 10−17 cm2. These measurements were combined with absorption measurements to calculate the gain spectra for NV- and NV0 for differing inversion levels. Such calculations indicate that gains approaching those required for laser operation may be possible with one of the samples tested and for the NV- centre.
3 January 2013 in IEEE Journal of Quantum Electronics
The variation in the Raman gain coefficient in single-crystal diamond for pump wavelengths between 355 and 1450 nm is measured. Two techniques are used: a pump-probe approach giving an absolute measurement and a stimulated Raman oscillation threshold technique giving a relative measurement. Both approaches indicate that the Raman gain coefficient is a linear function of pump wavenumber. With the pump polarized along a <; 111 >; direction in the crystal, the Raman gain coefficient measured by the pump-probe technique is found to vary from 7.6 ± 0.8 for a pump wavelength of 1280 nm to 78 ± 8 cm/GW for a pump wavelength of 355 nm. With the established dependence of the Raman gain coefficient on the pump wavelength, the Raman gain coefficient can be estimated at any pump wavelength within the spectral range from 355 up to 1450 nm.
1 January 2002 in Journal of the Optical Society of America B
Saturable-absorber mode locking and Q switching of neodymium-doped lasers at 1.06 µm with a PbS-doped glass were demonstrated. Q-switched pulses of 0.3 µJ in energy and 15 ns in duration from a cw diode-pumped laser and ultrashort pulses of 18 µJ in energy and 70 ps in duration from a laser were obtained. The saturation intensity of the PbS-doped glass (with an average semiconductor crystallite radius of 1.7 nm) was estimated to be 2.3 MW/cm2 at 1.06 µm. The bleaching relaxation time was measured to be 23 ps.
A comparative study of thermal lensing effect in diode laser pumped Ng- and Np-cut Nd:KGd(WO4)2 (KGW) laser crystals was performed for laser emission polarized along the principle refractive axis, Nm. The thermal lens in the Ng-cut Nd: KGW was found to be weakly astigmatic with a positive refractive power for both the Nm- and Np-directions. For Np -cut Nd:KGW, strong astigmatism was observed and the refractive powers in the Ng- and Nm-directions had opposing signs. The degree of astigmatism was found to be considerably weaker for the Ng-cut Nd:KGW in comparison with the Np-cut one: 0.35 dptr/(W/cm2) and 2.85 dptr/(W/cm2), respectively. The ratio of the thermal lens refractive powers in the planes parallel and perpendicular to the laser emission polarisation were measured as + 1.4 and −0.425 for Ng- and Np-cut Nd:KGW respectively.
A monolithic diamond Raman laser is reported. It utilizes a 13-mm radius of curvature lens etched onto the diamond surface and dielectric mirror coatings to form a stable resonator. The performance is compared to that of a monolithic diamond Raman laser operating in a plane–plane cavity. On pumping with a compact -switched laser at 532 nm (16 μJ pulse energy; 1.5 ns pulse duration; 10 kHz repetition-rate; ), laser action was observed at the first, second, and third Stokes wavelengths (573 nm, 620 nm and 676 nm, respectively) in both cases. For the microlens cavity, a conversion efficiency of 84% was achieved from the pump to the total Raman output power, with a slope efficiency of 88%. This compares to a conversion efficiency of 59% and a slope efficiency of 74% for the plane–plane case. Total Raman output powers of 134 and 96 mW were achieved for the microlens and plane–plane cavities, respectively.