Recent developments in semiconductor disk lasers (SDLs) generating visible or ultraviolet light are reviewed. After an introduction on potential applications, we discuss how the combination of vertical‐emitting semiconductor GaAs‐based structures and intra‐cavity nonlinear conversion techniques can be successfully exploited to uniquely meet demands for continuous‐wave radiation in the visible and ultraviolet spectral range. To do so, an overview of the device operating principles and performance is presented highlighting the underlying material considerations, semiconductor structural designs, thermal management techniques and suitable cavity configurations. This summary is completed by a presentation of new developments in the field, with a particular focus on the trends towards miniaturization.
24 January 2005 in IEEE Journal of Quantum Electronics
The use of crystalline heatspreaders to improve thermal management in optically pumped vertical-external-cavity surface-emitting lasers is studied via finite-element analysis. The required properties of a heatspreader are examined and the effect on heat flow is discussed, as are thermal lensing effects. The advantages of diamond heatspreaders are highlighted. The power-scaling potential is compared to other approaches. Heatspreaders are found to be promising, particularly for use with low thermal conductivity semiconductors.
We report the power scaling of a diode-pumped GaAs-based 850-nm vertical external-cavity surface-emitting laser, by use of an intracavity silicon carbide (SiC) heatspreader optically contacted to the semiconductor surface. To our knowledge, this is the first demonstration of bonding of SiC to a III-V semiconductor structure using the technique of liquid capillarity. High output power of >0.5 W in a circularly symmetric, TEM/sub 00/ output beam has been achieved with a spectral shift of only 0.6 nm/W of pump power. No thermal rollover was evident up to the highest pump power available, implying significant further output-power scaling potential using this approach.
High-power, continuous-wave operation at red wavelengths has been achieved with a vertical external cavity surface emitting laser based on the GaInP/AlGaInP/GaAs material system. Output power of 0.4W was obtained in a linearly polarized, circularly symmetric, diffraction-limited beam. A birefringent filter inserted in the cavity allowed tuning of the laser output spectrum over a 10nm range around 674nm.
An optically pumped red vertical-external-cavity surface-emitting laser with an AlInGaP gain region produced more than 1W of continuous-wave output power at a wavelength of 675nm. Frequency doubling in a beta-barium borate crystal placed at an intracavity beam waist generated 120mW of total output power at 338nm. Using an intracavity birefringent filter a second harmonic tuning range of ∼5nm was achieved.
15 December 2011 in IEEE Journal of Quantum Electronics
A continuous-wave diamond Raman laser is demonstrated with an output power of 5.1 W at 1217 nm. This Raman laser is intracavity pumped by a side-pumped Nd:YLF rod laser: a 43-fold brightness enhancement between the Nd:YLF and diamond Raman lasers is observed, with the M2 beam propagation factor of the diamond Raman laser measured to be <; 1.2. Although higher output powers are demonstrated in a similar configuration using KGd(WO4)2 (KGW) as the Raman laser material (6.1 W), the brightness enhancement is much lower (2.5 fold) due to the poorer beam quality of the KGW Raman laser (M2 <; 6). The Raman gain coefficient of single-crystal synthetic diamond at a pump wavelength of 1064-nm is also measured: a maximum value of 21±2 cm/GW is returned compared to 5.7±0.5 cm/GW for KGW at the same wavelength.