Kunihito Koumoto

Prof. Dr. Kunihito Koumoto

Department of Research, Nagoya Industrial Science Research Institute, Nagoya, Aichi 464-0819, Japan

Research Focus & Metrics

Academic Career Length

34Years (1993-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 August 2011 in Energy & Environmental Science
Verified
Journal Article
Closed access
PDF file
NWNing Wang
Ning Wang
LHLi Han
Li Han
HHHongcai He
Hongcai He
NPNam-Hee Park
Nam-Hee Park
KKKunihito Koumoto
Kunihito Koumoto
A novel photovoltaic–thermoelectric (PV–TE) hybrid device composed of a series-connected dye-sensitized solar cell (DSSC), a solar selective absorber (SSA) and a TE generator is created. The conversion efficiency of the DSSC was enhanced significantly by using the SSA and TE generator to utilize residual sunlight transmitted through the DSSC. The hybrid device comprising a DSSC as a “top cell” for high-energy photons and an SSA coated TE generator as a “bottom cell” for low-energy photons gave rise to an overall conversion efficiency larger than 13%. Although our hybrid device was not yet optimized but served as proof-of-principle for harvesting electricity from solar light and heat simultaneously with high conversion efficiency by a single device, this study would give some enlightenment for the development of high-performance PV–TE hybrid devices.

1 February 2010 in Science and Technology of Advanced Materials
Verified
Journal Article
Open access
CWChunlei Wan
Chunlei Wan
YWYifeng Wang
Yifeng Wang
NWNing Wang
Ning Wang
WNWataru Norimatsu
Wataru Norimatsu
MKMichiko Kusunoki
Michiko Kusunoki
KKKunihito Koumoto
Kunihito Koumoto
Thermal conductivity is one of the key parameters in the figure of merit of thermoelectric materials. Over the past decade, most progress in thermoelectric materials has been made by reducing their thermal conductivity while preserving their electrical properties. The phonon scattering mechanisms involved in these strategies are reviewed here and divided into three groups, including (i) disorder or distortion of unit cells, (ii) resonant scattering by localized rattling atoms and (iii) interface scattering. In addition, we propose construction of a 'natural superlattice' in thermoelectric materials by intercalating an MX layer into the van der Waals gap of a layered TX2 structure which has a general formula of (MX)1+x (TX2) n (M=Pb, Bi, Sn, Sb or a rare earth element; T=Ti, V, Cr, Nb or Ta; X=S or Se and n=1, 2, 3). We demonstrate that one of the intercalation compounds (SnS)1.2(TiS2)2 has better thermoelectric properties compared with pure TiS2 in the direction parallel to the layers, as the electron mobility is maintained while the phonon transport is significantly suppressed owing to the reduction in the transverse phonon velocities.

6 April 2010 in Materials
Verified
Journal Article
Open access
PDF file
CWChunlei Wan
Chunlei Wan
YWYifeng Wang
Yifeng Wang
NWNing Wang
Ning Wang
KKKunihito Koumoto
Kunihito Koumoto
A series of (MS)1+x(TiS2)2 (M = Pb, Bi, Sn) misfit layer compounds are proposed as bulk thermoelectric materials. They are composed of alternating rock-salt-type MS layers and paired trigonal anti-prismatic TiS2 layers with a van der Waals gap. This naturally modulated structure shows low lattice thermal conductivity close to or even lower than the predicted minimum thermal conductivity. Measurement of sound velocities shows that the ultra-low thermal conductivity partially originates from the softening of the transverse modes of lattice wave due to weak interlayer bonding. Combined with a high power factor, the misfit layer compounds show a relatively high ZT value of 0.28~0.37 at 700 K.

29 March 2011 in Journal of Electronic Materials
Verified
Journal Article
Closed access
PDF file
CWChunlei Wan
Chunlei Wan
YWYifeng Wang
Yifeng Wang
NWNing Wang
Ning Wang
WNWataru Norimatsu
Wataru Norimatsu
MKMichiko Kusunoki
Michiko Kusunoki
KKKunihito Koumoto
Kunihito Koumoto

16 September 2010 in Nanoscale
Verified
Journal Article
Closed access
PDF file
KFKyoichi Fujinami
Kyoichi Fujinami
KKKiyofumi Katagiri
Kiyofumi Katagiri
JKJumpei Kamiya
Jumpei Kamiya
THTadashi Hamanaka
Tadashi Hamanaka
KKKunihito Koumoto
Kunihito Koumoto
Strontium titanate (SrTiO3) nanoparticles with well defined cubic shape and sub-10 nm size that are highly dispersible in non-polar organic solvents were successfully synthesized by hydrothermal (HT) processing. Water-soluble titanium complexes and strontium hydroxide were employed as precursors. When the HT process was carried out without oleic acid, the SrTiO3 particles obtained were relatively large and aggregated. However, SrTiO3 nanocubes that are highly dispersible in hexane were obtained via the HT process using oleic acid and hydrazine.

17 July 2006 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
KSKenji Sugiura
Kenji Sugiura
HOHiromichi Ohta
Hiromichi Ohta
KNKenji Nomura
Kenji Nomura
MHMasahiro Hirano
Masahiro Hirano
HHHideo Hosono
Hideo Hosono
KKKunihito Koumoto
Kunihito Koumoto
Epitaxial film of a layered cobalt oxide, Ca3Co4O9 , was fabricated on a (0001) face of an α-Al2O3 substrate by a topotactic ion-exchange method using a γ-Na0.8CoO2 epitaxial film as a precursor. High-resolution x-ray diffraction and atomic force microscope measurements revealed that the film was high-quality (001)-oriented Ca3Co4O9 with stepped and terraced surface morphology. The film exhibits a high electrical conductivity of 2.95×102Scm−1 and a large Seebeck coefficient of ∼+125μVK−1 , which leads to the thermoelectric power factor (TPF) of 4.5×10−4Wm−1K−2 at 300K , potentially usable as a building block of the multilayered film structure with an enhanced TPF value.