3 August 2011 in Energy & Environmental Science
A novel photovoltaic–thermoelectric (PV–TE) hybrid device composed of a series-connected dye-sensitized solar cell (DSSC), a solar selective absorber (SSA) and a TE generator is created. The conversion efficiency of the DSSC was enhanced significantly by using the SSA and TE generator to utilize residual sunlight transmitted through the DSSC. The hybrid device comprising a DSSC as a “top cell” for high-energy photons and an SSA coated TE generator as a “bottom cell” for low-energy photons gave rise to an overall conversion efficiency larger than 13%. Although our hybrid device was not yet optimized but served as proof-of-principle for harvesting electricity from solar light and heat simultaneously with high conversion efficiency by a single device, this study would give some enlightenment for the development of high-performance PV–TE hybrid devices.
18 February 2015 in Nano Letters
17 February 2014 in RSC Advances
The nanoparticles of Al-doped ZnO were successfully grown into rod-like and platelet-like morphologies by soft chemical routes. These powders were consolidated using spark plasma sintering (SPS) technique. The samples consolidated from rods and platelets exhibited characteristic structures with preferential orientation while the sample consolidated from nanoparticles did not show any sign of preferential orientation. The measured ZT values along the preferred orientation directions were found to be 0.16 and 0.25 at 1223 K for the samples consolidated from rods and platelets, respectively. The sample consolidated from nanoparticles exhibited fine grains and highly distributed nanoprecipitates, resulting in a ZT value of 0.3 at 1223 K due to the lower thermal conductivity resulting from nanostructuring. Using the simple parabolic band model and Debye–Callaway thermal transport model, the anisotropic properties of the nanostructured samples were elucidated and the influence of the grain size and nanoprecipitates on the electron and phonon transport was analyzed and discussed in detail.
1 March 2017 in Synthetic Metals
1 April 2013 in Journal of Alloys and Compounds
10 June 2016 in RSC Advances
Bismuth antimony telluride Bi0.4Sb1.6Te3 samples were prepared under various conditions using spark plasma sintering and the effects on the anisotropic thermoelectric properties and microstructure evolutions were systematically investigated.