Serious membrane fouling has limited the development of ultrafiltration membrane technology for water purification. Synthesis of an ultrafiltration membrane with prominent anti-fouling ability is of vital importance. In this study, CAB−GO composite nanosheets were prepared by grafting graphene oxide (GO) with a zwitterionic material cocamidopropyl betaine (CAB) with strong antifouling properties. Anti-fouling CAB−GO/PES mixed matrix ultrafiltration membrane (CGM) was prepared by the phase inversion method with polyethersulfone (PES). Due to its electrostatic interaction, the interlayer distance between CAB−GO nanosheets was increased, and the dispersibility of GO was improved to large extent, thereby effectively avoiding the phenomenon of GO agglomeration in organic solvents. Based on the improvement of the surface porosity and surface hydrophilicity of the CAB−GO/PES mixed matrix membrane, the pure water flux of CGM−1.0 can reach 461 L/(m2·h), which was 2.5 times higher than that of the original PES membrane, and the rejection rates toward BSA and HA were above 96%. Moreover, when the content of CAB−GO was 0.1 wt%, the prepared CAB−GO/PES membrane exhibited very high BSA (99.1%) and HA (98.1%) rejection during long-term operation, indicating excellent anti-fouling ability.
In this work, Ag nanoparticle loading Mg(C10H16O4)2(H2O)2(Ag@MOF) composite material was successfully prepared by a facile strategy, and subsequently Ag-MOFs were used to modify the PVDF ultrafiltration membranes to obtain fouling resistance and higher water flux. The as-prepared PVDF membranes were systematically characterized by a series of analytical techniques such as Water Contact Angle (CA), Scanning Electron Microscopy (SEM), and SEM-mapping. Furthermore, the performance of membranes on antibacterial properties, the pure water flux, and fouling resistance was investigated in detail. Those results showed that the membrane modified by Ag@MOFs containing 30% Ag had the higher anti-bacterial performance, and the clear zone could be increased to 10 mm in comparison with that of blank membrane. Meanwhile, the pure water flux of Ag@MOF membranes increased from 85 L/m2 h to 157 L/m2 h, and the maximum membrane flux recovery rate (FRR) of 95.7% was obtained using SA as pollutant, which is attributed to the introduction of Ag@MOF composite material. Based on the above experimental results, it can be found that the Ag-MOF membranes displayed the excellent antibacterial activity, high water flux, and fine fouling resistance. This work provides a facile strategy to fabricate the Ag@MOFs modified membranes, and it shows an excellent anti-bacterial and water flux performance.