Lorena Armenta-Villegas

Dr. Lorena Armenta-Villegas


Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 October 2026 in Macromol
Verified
Journal Article
Open access
PDF file
AGAna Victoria Tapia Gastélum
Ana Victoria Tapia Gastélum
CBCarlos Gregorio Barreras-Urbina
Carlos Gregorio Barreras-Urbina
José Agustín Tapia HernándezJosé Agustín Tapia Hernández
José Agustín Tapia Hernández
FRFrancisco Rodriguez
Francisco Rodriguez
TMTOMAS J. MADERA-SANTANA
TOMAS J. MADERA-SANTANA
IQIdania Emedith Quintero-Reyes
Idania Emedith Quintero-Reyes
Electrospraying has emerged as a promising technique for producing biopolymeric structures containing bioactive compounds. In this study, gelatin and gelatin–curcumin nanoparticles were produced by uniaxial electrospraying, and the effects of gelatin and curcumin extract concentrations on their rheological, morphological, and physicochemical characteristics were evaluated. Gelatin solutions (5–15% w/v) were first characterized by rheological analysis, which exhibited Newtonian flow behavior over the evaluated concentration range, favorable for the electrospraying process. Electrospraying was performed at fixed conditions of 15 kV voltage, 0.1 mL h−1 flow rate, and 10 cm tip-to-collector distance. Increasing gelatin concentrations influenced the resulting morphology, with structures ranging from pearled fibers to spherical particles and, at higher concentrations, fibers with few pearls. Gelatin structures exhibited mean hydrodynamic diameters of 420.63–762.66 nm, determined by dynamic light scattering (DLS), with PDI values of 0.49–0.89. At a fixed gelatin concentration of 8% (w/v), varying curcumin extract concentration from 1 to 5% (w/v) resulted in a non-linear change in particle size, with mean diameters ranging from 196.30 to 622.16 nm and PDI values of 0.60–0.79. The selected formulation containing 8% (w/v) gelatin and 5% (w/v) curcumin extract exhibited the highest absolute zeta potential (−28.56 ± 1.25 mV), suggesting a lower tendency toward particle aggregation. Fourier transform infrared spectroscopy (FTIR) supported molecular interactions between gelatin and curcumin. Overall, the results demonstrate that formulation composition influences the morphology, particle size distribution, and surface charge of gelatin–curcumin structures produced by uniaxial electrospraying. Further studies are required to evaluate encapsulation efficiency, curcumin storage stability, release behavior, and biological performance.

19 October 2026 in Coatings
Verified
Journal Article
Open access
PDF file
ELEMELY GUADALUPE RIVERA LÓPEZ
EMELY GUADALUPE RIVERA LÓPEZ
MAMaritza Lizeth Alvarez-Ainza
Maritza Lizeth Alvarez-Ainza
LALorena Armenta-Villegas
Lorena Armenta-Villegas
ISIrela Santos-Sauceda
Irela Santos-Sauceda
DEDaniela Denisse Castro Enríquez
Daniela Denisse Castro Enríquez
Ramón Francisco Dórame-MirandaRamón Francisco Dórame-Miranda
Ramón Francisco Dórame-Miranda
Valorizing agro-industrial by-products as feedstocks for coatings and biomaterials offers a sustainable route to value-added materials. This study investigated the effects of pecan nutshell extract (PNSE) and glycerol on the physicochemical, bioactive, and antibacterial properties of functionalized bacterial cellulose (BC) films. PNSE showed a high phenolic and flavonoid content and substantial antioxidant capacity (DPPH, ABTS, and FRAP). BC-based films containing PNSE and glycerol were subsequently characterized by FTIR, SEM, TGA/DTG, and DSC, and their antibacterial activity was evaluated by disk diffusion against Staphylococcus aureus ATCC 25923, Escherichia coli ATCC 35218, and Salmonella typhimurium ATCC 14028. The extract contained 742.91 ± 4.04 mg GAE/g of total phenolic compounds, 82.42 ± 0.67 mg CE/g of flavonoids, and 475.13 ± 2.84 µmol TE/g in the DPPH assay. ATR-FTIR revealed spectral changes consistent with interactions among cellulose hydroxyl groups, glycerol, and phenolic constituents of PNSE. SEM revealed changes in surface morphology, and TGA/DTG recorded degradation temperatures of up to 386 °C. The BC-PNSE-GC-4 formulation exhibited the strongest antibacterial activity against S. aureus, demonstrating an inhibition zone of 18 mm. The developed films show promising potential for use in active food packaging applications.

15 September 2026 in Micro
Verified
Journal Article
Open access
PDF file
SLSebastián Guzmán León
Sebastián Guzmán León
CBCarlos Gregorio Barreras-Urbina
Carlos Gregorio Barreras-Urbina
TMTOMAS J. MADERA-SANTANA
TOMAS J. MADERA-SANTANA
LALorena Armenta-Villegas
Lorena Armenta-Villegas
MAMaritza Lizeth Alvarez-Ainza
Maritza Lizeth Alvarez-Ainza
FRFrancisco Rodriguez
Francisco Rodriguez
Curcuma longa L. rhizomes contain curcuminoids and other compounds of interest, but their incorporation into aqueous systems is limited by poor dispersibility and chemical instability. This study formulated gelatin–Curcuma longa L. extract nanoparticles by coaxial electrospraying. A dried hydroethanolic extract was obtained from commercial Curcuma longa L. powder by ultrasound-microwave-assisted extraction (UMAE), with a mean gravimetric yield of 12.46 ± 1.47%. Because the recovered material was not purified or quantified by a compound-specific method, it is described as Curcuma longa L. extract rather than curcumin. Gelatin solutions at 8 and 10% (w/v) were used as the outer feed, whereas extract solutions at 0.1, 0.5, and 1.0% (w/v) were used as the inner feed. The precursor solutions showed near-Newtonian behavior. The 8% gelatin–0.5% extract formulation exhibited predominantly spherical morphology, a hydrodynamic diameter of 266.27 ± 0.57 nm, and the lowest PDI (0.24 ± 0.01). FTIR-ATR results were consistent with non-covalent interactions, mainly hydrogen bonding. These findings support coaxial electrospraying as a suitable method for preparing gelatin–Curcuma longa L. extract nanoparticles.