High current, efficiency, and compactness are the key challenges of dc/dc converters for all dc renewable system. In this letter, a dc/dc converters is proposed to address these challenges. The proposed converter incorporates three key innovations: parallel operation, direct transmission of partial power, and non-ac energy balancing. Through parallel operation, the converter facilitates the sharing of current across multiple strings of submodules, resulting in high current capability. Furthermore, the integration of direct transmission of partial power and non-ac energy balancing minimize installations of insulated gate bipolar transistors (IGBTs) and capacitors, contributes to enhanced efficiency and compactness. The effectiveness and validity of the proposed converter are demonstrated through simulation and experimental results.
2 April 2025 in IEEE Transactions on Power Electronics
Bidirectional dc transformer (DCT) is the key energy conversion equipment for all-dc collection and transmission system. Cost, efficiency, and dc fault blocking capability are important considerations that are currently difficult to address simultaneously for the existing modular multilevel converter (MMC) based DCT. In this article, a bidirectional hybrid isolated dc transformer (BHIT) as an alternative to the existing MMC based DCT is proposed. By replacing half of the submodules (SMs) by antiparalleled thyristors, the proposed BHIT can reduce 36.7% device cost, 32.5% device loss, and 64.8% total SM capacitance compared with the existing MMC based DCTs. By tailoring the trapezoidal waveforms of the thyristors, continuous dc currents are ensured without any filtering effort. In addition, an active fault current limiting control is further proposed to reduce the fault current during short-circuit faults. The detailed operational analysis, control schemes, simulation results, and scale-down prototype are provided to validate the effectiveness of proposed topology.
20 September 2024 in IEEE Transactions on Power Electronics
This article proposes an isolated three-port power router (TP-PR) for medium-voltage (MV) dc collection of large-scale photovoltaic applications with a portion of ac power integration. By combining the modular multilevel converter (MMC) with thyristor valves through integrated transformers, not only the MVdc-side installed semiconductor capacity is reduced but also the requirement for MV-side submodule (SM) capacitor is eliminated. Particularly, the MMC utilizes high-frequency current for MV dc power transfer, effectively minimizing the requirement for SM capacitance. Moreover, the low on -state voltage drop of thyristors, along with zero-voltage switching and zero-current switching techniques, ensures low conversion loss for TP-PR. Compared with the traditional isolated three-port topology, TP-PR can reduce semiconductor cost by 22%, SM capacitance energy storage by 49%, and conversion loss by 50%. The operation principle, key parameters design, and multiport control strategy are introduced in detail. The effectiveness and the theoretical analysis have been confirmed by both simulation and experimental results.
30 September 2024 in IEEE Transactions on Power Electronics
The rapid growth of renewable energy installation promotes the development of high voltage direct current (HVdc) links for energy integration and transmission. To meet the future needs of HVdc grids, high-voltage dc–dc converters are needed to interconnect HVdc links with different voltage levels. This article proposes a high-voltage active filtering dc–dc converter composed of only one energy buffering arm to transfer energy and two active filtering arms for dc current continuity. This topology features low cost and small footprint. The circuit configuration, operation principle, parameter design, and control strategies are presented. Particularly, the decoupling control is proposed to solve the coupling among energy balance control of different arms. Both the simulation case of 100 MW, 200 kV/320 kV, and downscaled experimental results of 1.5 kW, 150 V/300 V are provided to demonstrate the validity of the proposed topology. Furthermore, a series of dc–dc topologies with active filtering principle are derived and evaluated.
18 December 2024 in IEEE Transactions on Power Electronics
Meshed HVDC grid is instrumental in enhancing transmission capability and mitigating power fluctuations of renewable power generations. However, meshed dc grid cannot fully regulate the current flow through each line. To address the problem, this article presents a novel design for dc power flow controller (DCPFC) that enhances power flow control capability of meshed HVDC grid while minimizing the use of semiconductors. Benefits could be especially valuable in multiport applications. The circuit structure, operating waveforms, parameters, and control design are presented. The start process of the proposed DCPFC is also introduced. Simulation results and downscaled experimental tests are performed for demonstrating the effectiveness of the proposed topology.
18 June 2025 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Medium voltage direct current (MVDC) collection is a promising approach for integration of large-scale renewables. This paper proposes a series resonant DC/DC converter for MVDC collection with certain DC voltage gain adjustment capability. By adding an auxiliary half-bridge and a low-insulation-level auxiliary transformer to the traditional series resonant DC/DC converter, the proposed converter allows flexible voltage gain adjustment. All semiconductor devices in the system can achieve soft switching over the entire voltage and power range, resulting in high operation efficiency. The analysis includes a detailed examination of the plane trajectory to assess device stresses, voltage gain, and design methods for resonant parameters. Simulation results validate the proposed approach, and the experimental results from a scaled down prototype further proves the effectiveness.