Wave-induced extreme water levels in the Puerto Morelos fringing reef lagoon are investigated by means of a phase-resolving non-hydrostatic wave model (SWASH). This model solves the nonlinear shallow water equations including non-hydrostatic pressure. The one-dimensional version of the model is implemented in order to investigate wave transformation in fringing reefs. Firstly, the numerical model is validated with (i) laboratory experiments conducted on a physical model (Demirbilek et al., 2007)and (ii) field observations (Coronado et al., 2007). Numerical results show good agreement with both experimental and field data. The comparison against the physical model results, for energetic wave conditions, indicates that high- and low-frequency wave transformation is well reproduced. Moreover, extreme water-level conditions measured during the passage of Hurricane Ivan in Puerto Morelos are also estimated by the numerical tool. Subsequently, the model is implemented at different along-reef locations in Puerto Morelos. Extreme water levels, wave-induced setup, and infragravity wave energy are estimated inside the reef lagoon for different storm wave conditions (Hs >2 m). The numerical results revealed a strong correlation between the offshore sea-swell wave energy and the setup. In contrast, infragravity waves are shown to be the result of a more complex pattern which heavily relies on the reef geometry. Indeed, the southern end of the reef lagoon provides evidence of resonance excitation, suggesting that the reef barrier may act as either a natural flood protection morphological feature, or as an inundation hazard enhancer depending on the incident wave conditions.
We present a downscaling approach for the study of wave-induced extreme water levels at a location on a barrier island in Yucatán (Mexico). Wave information from a 30-year wave hindcast is validated with in situ measurements at 8 m water depth. The maximum dissimilarity algorithm is employed for the selection of 600 representative cases, encompassing different combinations of wave characteristics and tidal level. The selected cases are propagated from 8 m water depth to the shore using the coupling of a third-generation wave model and a phase-resolving non-hydrostatic nonlinear shallow-water equation model. Extreme wave run-up, R2%, is estimated for the simulated cases and can be further employed to reconstruct the 30-year time series using an interpolation algorithm. Downscaling results show run-up saturation during more energetic wave conditions and modulation owing to tides. The latter suggests that the R2% can be parameterized using a hyperbolic-like formulation with dependency on both wave height and tidal level. The new parametric formulation is in agreement with the downscaling results (r2 = 0.78), allowing a fast calculation of wave-induced extreme water levels at this location. Finally, an assessment of beach vulnerability to wave-induced extreme water levels is conducted at the study area by employing the two approaches (reconstruction/parameterization) and a storm impact scale. The 30-year extreme water level hindcast allows the calculation of beach vulnerability as a function of return periods. It is shown that the downscaling-derived parameterization provides reasonable results as compared with the numerical approach. This methodology can be extended to other locations and can be further improved by incorporating the storm surge contributions to the extreme water level.
The understanding of the beach capability to resist and recover from a disturbance is of paramount importance in coastal engineering. However, few efforts have been devoted to quantifying beach resilience. The present work aims to investigate the shoreline resistance and resilience, associated to a transient disturbance, on a sandy beach. A temporary groin was deployed for 24 h on a micro-tidal sea-breeze dominated beach to induce a shoreline perturbation. Morphological changes were measured by means of beach surveys to estimate the beach perturbation and the further beach recovery after structure removal. An Empirical Orthogonal Function (EOF) analysis of the shoreline position suggests that the first EOF mode describes the spatial-temporal evolution of the shoreline owing to the groin deployment/removal. A new one-line numerical model of beach evolution is calibrated with the field surveys, reproducing both the sediment impoundment and subsequent beach recovery after the structure removal. Thus, a parametric numerical study is conducted to quantify resistance and resilience. Numerical results suggest that beach resistance associated to the presence of a structure decreases with increasing alongshore sediment transport potential, whereas resilience after structure removal is positively correlated with the alongshore diffusivity.
Video monitoring has become an indispensable tool to understand beach processes. However, the measurement accuracy derived from the images has been taken for granted despite its dependence on the calibration process and camera movements. An easy to implement self-fed image stabilization algorithm is proposed to solve the camera movements. Georeferenced images were generated from the stabilized images using only one calibration. To assess the performance of the stabilization algorithm, a second set of georeferenced images was created from unstabilized images following the accepted practice of using several calibrations. Shorelines were extracted from the images and corrected with the measured water level and the computed run-up to the 0 m contour. Image-derived corrected shorelines were validated with one hundred beach profile surveys measured during a period of four years along a 1.1 km beach stretch. The simultaneous high-frequency field data available of images and beach surveys are uncommon and allow assessing seasonal changes and long-term trends accuracy. Errors in shoreline position do not increase in time suggesting that the proposed stabilization algorithm does not propagate errors, despite the ever-evolving vegetation in the images. The image stabilization reduces the error in shoreline position by 40 percent, having a larger impact with increasing distance from the camera. Furthermore, the algorithm improves the accuracy on long-term trends by one degree of magnitude (0.01 m/year vs. 0.25 m/year).