High-performance thermal protection materials are urgently required in harsh thermal environments, such as hypersonic vehicles, the thermal runaway of energy batteries and high-temperature equipment. Conventional aerogels only exhibit passive thermal insulation and fail to resist instantaneous high-temperature attack. Herein, a cooling material of ammonium oxalate (AO) was introduced to achieve efficient, active endothermic protection. A cellular isolation effect induced by graphene nanosheets combined with anti-solvent crystallization was adopted to significantly decrease the size of AO crystals by over 93%. Based on superfine morphology and the constructed conduction network, the decomposition rate and heat absorption capacity of obtained graphene-doped AO powders (GdAPs) are improved by 41.2% and 30.4%, respectively. The mechanisms of morphology regulation and enhanced heat absorption are explored specifically in this study. Furthermore, GdAPs are embedded in phenolic resin to prepare thermal protection composite materials. Benefiting from their nearly complete thermal decomposition, GdAPs serve as a sacrificial template to generate discrete micropores in pyrolyzed resin. So, the as-prepared carbon aerogels (CAs) with a regulable microstructure exhibit an extremely low thermal conductivity of 0.056 W/(m·K), which is lower than those of reported CAs with the same density. Based on the above advantages, a synergistic endothermic-insulating thermal protection material is reported for the first time, and its heating rate is only 28.6% of that of commercial silica aerogel under identical high-temperature shock. Therefore, a new accessible strategy is demonstrated to provide high-efficiency thermal protection for resisting both abrupt and prolonged high temperature.
Laser-induced graphene (LIG) has great potential for multiple applications because of its large specific surface area, facile fabrication process, and tunable properties. However, abundant lattice defects severely degrade its conductivity. Herein, from an innovative perspective of precursor design, the poly-phenylamines (P-PAs) with improved solubility and strong light absorption were synthesized, which act as an intercalated polymer for graphene oxide (GO) nanosheets. On this basis, the composite precursors show remarkably enhanced photothermal conversion capability and a compact stacked structure. These bring a 60% reduction in ID/IG in LIG after laser irradiation. To explain the above phenomenon, an isolation effect induced by the compact stacking precursor is proposed based on experimental results. Furthermore, the cooperative effect between P-PAs and Fe2+ is introduced, and a fluffy LIG aerogel with the lowest ID/IG ratio of 0.17 is prepared, which is barely achievable in conventional LIGs. When the obtained graphene aerogel is compounded with PDMS, the as-prepared thermal-conductive composite gel reaches a thermal conductivity of 1.05 W·m−1·K−1 and an ultralow interfacial thermal resistance of 37.2 mm2·K·W−1 under a low graphene loading of 3.3 wt%. This intercalation strategy in GO precursor supplies a new route for preparing high-quality LIGs and thermal-conductive gels, which show great application prospects in thermal management devices.