In this paper, a selective and sensitive photonic crystal (PC) sensor is designed to detect two types of alcohol, namely ethanol and methanol and to measure their concentration percentages. The use of different concentrations of each compound leads to a change in their densities which have definite correlations with the refractive indexes based on the Gladstone–Dale theory. According to the experimental results and the Gladstone–Dale theory, the value of the refractive index in different percentages of alcohols overlaps, which makes it difficult to detect them with optical techniques. We present a new solution to solve this problem, which is very interesting. The FWHMs for spectrum of the ethanol and methanol mixtures with water are obtained as 1.2 nm and 1.4 nm, respectively. This way, it is possible to distinguish between two types of alcohols. After this process and by diluting the solution of each of the alcohols below 30%, the overlap of the refractive indexes is prevented and the obtained resonance wavelength can be attributed to a determined percentage of alcohol. The performance parameters of the proposed sensor for both alcohols are quite promising so that the transmission, the quality factor, the sensitivity and the FOM are above 97%, 1092, 756 nm/RIU and 593.9 RIU-1 respectively. Even, when two typical samples have the same refractive indexes, the sensor can distinguish the alcohol type and the sample’s concentration. This capability along with the small size (123 μm2) and high sensitivity, are the special features of the proposed PC sensor.
9 February 2024 in Materials Science in Semiconductor Processing
In this work, a photonic crystal fiber (PCF) refractive index (RI) sensor has been designed and optimized. The RIs range covered by the sensor is from 1.38 to 1.41. The proposed optical sensor has three layers of air holes with 24, 12 and 6 holes in each layer. The geometry parameters of the proposed sensor (the radius of the air holes and the thickness of the plasmonic layer) have been optimized using the Nelder-Mead algorithm and the FEM numerical with the objective of achieving the highest sensitivity. To achieve an optimized structure with minimal sensitivity to fabrication errors, the rotation angle of the hole layers has been analyzed. The results indicate that, due to the specific geometry of the proposed structure, variations in the rotation angle and displacement of the air holes have no significant impact on the outcomes. The results also indicate that the sensor’s maximum amplitude sensitivity (AS), maximum wavelength sensitivity (WS), and figure of merit (FOM) are 10000 (RIU−1), 23000 (nm/RIU) and 131 (RIU−1) respectively. The optimized design provides high sensitivity, a wide diagnostic range for the detection of the analytes’ RIs, and the advantages of a gold plasmonic layer, ensuring high stability in biological environments. This combination results in enhanced performance of the sensor for various applications particularly in biosensing and medical fields. The designed structural geometry also eliminates the effects of tolerances in manufacturing processes which makes the proposed PCF device a very efficient sensor.
26 January 2018 in Journal of Optical Communications
In this article, a 2D photonic crystal (PC)-based optical filter has been designed using a PC ring resonator. The resonator used is of square type with a square lattice constant, which has been designed by increasing the radius of the inner rods of the resonator. The filter designed can separate the light of the wavelength of 1545.3 nm with a transmission coefficient of 98 %. The bandwidth of the above wavelength is equal to 0.5 nm and hence the quality factor of the device at this wavelength is equal to 3091. The effects of the structural parameters, such as the refractive index, the lattice constant, the radius of the dielectric rods, the radius of the inner rods of the resonator on the behavior of the proposed device, are fully investigated. To obtain the photonic band gap, the plane wave expansion method is used. In addition, the finite difference time domain method is used to examine, simulate, and to obtain the output spectrum of the structure. The designed structure has both high transmission coefficient and quality factor. Comparatively speaking, it is also simple to design which justifies its use in other photonic crystal-based optical devices.