Wire electrochemical discharge machining (WECDM) integrates the effectiveness of electrical discharge machining (EDM) with the superior quality of electrochemical machining (ECM), leading to enhanced machining efficiency, excellent surface finish, and significant potential for advancement. However, previous research has mainly focused on the processing of non-metallic materials, with little research in the field of the microfabrication of thick metal materials. The wire electrochemical discharge machining process with large aspect ratios is more complex. Accordingly, a unidirectional traveling wire electrochemical discharge micromachining (UWECDMM) method using a glycol-based electrolyte was proposed. The method employs a glycol solution with low conductivity and a neutral salt, facilitating enhanced mass transfer efficiency through a unidirectional traveling wire, and enabling the realization of high-efficiency, high-precision, and recast-free processing. The phenomenon of discharge in UWECDMM was observed in real-time with a high-speed camera, while the voltage and current waveforms throughout the machining process were carefully analyzed. It was found that electrolysis and discharge alternate. Experiments were conducted to investigate the wire traveling pattern, the recast layer, and the wear of the wire electrode. It was found that due to the small energy of a single discharge, the wear of wire electrodes is minimal after multiple uses and can be reused. Under optimal parameters, a machined surface without a recast layer can be obtained. In the final stages, a standard structure was machined on plates of 10 mm thickness made of pure nickel and 304 stainless steel, using a tungsten wire measuring 30 μm in diameter. The feed rate achieved was 1 μm/s, the surface roughness (Ra) measured 0.06 μm, and the absence of a recast layer confirmed the method’s sustainability and quality traits, indicating significant potential in microfabrication.

Electrochemical machining is widely recognized as a high-efficiency, low-cost and high-precision non-traditional machining technology for the manufacturing of turbine blade components. Nevertheless, in the practical electrochemical machining of turbine blades, the uneven spatial distribution of electric field intensity within the inter-electrode machining gap inevitably causes inconsistent anodic dissolution, which significantly deteriorates the final surface quality of machined blades. A set of comparative machining experiments were conducted on Inconel 625 superalloy. The experimental results fully verified that pulsed current machining could effectively improve the surface integrity and surface quality, and the optimal matching electrical parameters were successfully determined through systematic data analysis. The essential improvement mechanism lied in the effective suppression of stray current-induced scattered dissolution under pulsed power supply, which was highly consistent with the numerical simulation conclusions.

The advanced manufacturing of metal micro-holes is of great significance in various fields of industrial production, including aerospace, automotive, electronics, and healthcare. New technologies are constantly emerging, including various multi-energy field manufacturing technologies, and the knowledge system is complex and intricate. The present article summarizes recent advancements in metal micro-hole manufacturing technologies, drawing parallels with existing laser processing and electrochemical processing technologies. The present systematic review has been conducted with the objective of providing a comprehensive overview of the latest methodologies. The present review paper is of particular significance in that it encompasses not only the fundamental principles and innovative process methods, but also the most recent research progress and current problems. Furthermore, a synopsis of the developmental trajectory of advanced sustainable manufacturing technology for micro-holes was furnished.