Daoda Zhang

Prof. Dr. Daoda Zhang


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 September 2021 in Materials
Verified
Journal Article
Open access
PDF file
YXYong Xin
Yong Xin
DZDaoda Zhang
Daoda Zhang
ZHZhi Hu
Zhi Hu
The microstructural and wear properties of laser-cladding WC/Ni-based layer on Al–Si alloy were investigated by scanning electron microscope (SEM), X-ray diffraction (XRD), energy dispersive spectrometer (EDS) and wear-testing. The results show that, compared with the original specimen, the microhardness and wear resistance of the cladding layer on an Al–Si alloy were remarkably improved, wherein the microhardness of the layer achieved 1100 HV and the average friction coefficient of the layer was barely 0.14. The mainly contributor to such significant improvement was the generation of a WC/Ni-composite layer of Al–Si alloy during laser cladding. Two types of carbides, identified as M7C3 and M23C6, were found in the layer. The wear rate of the layer first increased and then decreased with the increase in load; when the load was 20 N, 60 N and 80 N, the wear rate of layer was1.89 × 10−3 mm3·m−1, 3.73 × 10−3 mm3·m−1 and 2.63 × 10−3 mm3·m−1, respectively, and the average friction coefficient (0.14) was the smallest when the load was 60 N.

3 December 2025 in Coatings
Verified
Journal Article
Open access
PDF file
DZDaoda Zhang
Daoda Zhang
Longzhi ZhaoLongzhi Zhao
Longzhi Zhao
WCWanglin Chen
Wanglin Chen
JLJunjie Luo
Junjie Luo
HZHongbo Zhou
Hongbo Zhou
XZXiaomin Zheng
Xiaomin Zheng
This study fabricated six types of NiCr–Cr3C2 composite coatings using high-velocity oxygen fuel (HVOF) spraying and systematically evaluated their tribological behavior at 350 °C and 500 °C, along with their electrochemical corrosion performance in 3.5 wt.% NaCl solution. The objective was to elucidate how compositional design regulates the coatings’ microstructure, mechanical properties, and service performance. Results indicate that the 75NiCr–25Cr3C2 coating (C) formed a stable oxide film under both temperatures, exhibiting oxidation-dominated wear and the lowest friction coefficient and wear rate. When the temperature increased from 350 °C to 500 °C, the wear rates of coatings C, B, E, and F decreased significantly. Notably, coatings E and F, which contained CoCrFeNiMo high-entropy alloy, showed more than a 50% reduction in wear rate, demonstrating the contribution of the high-entropy phase to high-temperature wear resistance. At 350 °C, coatings B, D, E, and F experienced primarily abrasive wear; at 500 °C, however, E and F shifted to oxidative wear as the dominant mechanism, leading to a marked improvement in wear resistance. Electrochemical measurements revealed that coating E exhibited the best corrosion resistance, while the NiCr coating (A) performed the worst. The findings highlight that optimizing Cr3C2 content and incorporating high-entropy alloy elements can synergistically enhance both high-temperature tribological properties and corrosion resistance.