A high load of inorganics in raw lignocellulosic biomass is known to inhibit the yield of bio-oil and alter the chemical reactions during fast pyrolysis of biomass. In this study, palm kernel shell (PKS), an agricultural residue from palm oil production, and two other woody biomass samples (mahogany (MAH) sawdust and iroko (IRO) sawdust) were pretreated with distilled water or an acidic solution (either acetic, formic, hydrochloric (HCl) or sulfuric acid (H₂SO₄)) before fast pyrolysis in order to investigate its effect on the primary products and pyrolysis reaction pathways. The raw and pretreated PKS, MAH and IRO were pyrolysed at 600 °C and 5 s with a micro-pyrolyser connected to a gas chromatograph–mass spectrometer/flame ionisation detector (GC-MS/FID). Of the leaching solutions, HCl was the most effective in removing inorganics from the biomass and enhancing the primary pyrolysis product formed compared to the organic acids (acetic and formic acid). The production of levoglucosan was greatly improved for all pretreated biomasses when compared to the original biomass but especially after HCl pretreatment. Additionally, the relative content of the saccharides was maximised after pretreatment with H₂SO_4, which was due to the increased production of levoglucosenone. The relative content of the saccharides increased by over 70%. This increase may have occurred due to a possible reaction catalysed by the remaining acid in the biomass. The production of furans, especially furfural, was increased for all pretreatments but most noticeable when H₂SO₄ was used. However, the relative content of acids and ketones was generally reduced for PKS, MAH and IRO across all leaching solutions. The relative content of the phenol-type compound decreased to a large extent during pyrolysis after acid pretreatment, which may be attributed to dehydration and demethoxylation reactions. This study shows that the production of valuable chemicals could be promoted by pretreatment with different acid solutions.

Sewage sludge is regarded as a potential source for soil fertilizer However, the direct utilization of sewage sludge in agricultural land is restricted since it also contains heavy metals, pathogens, and toxic compounds. Pyrolysis of the sewage sludge destroys the organic pollutants and partly volatilizes the heavy metals. In this study, pyrolysis of sewage sludge was carried out in order to determine the optimum residence time and temperature to recover the phosphorous and remove heavy metals from the resultant sewage sludge char (SSC). Pyrolysis was conducted on dried sewage sludge (DSS) by means of thermogravimetric analysis (TGA) and high-temperature oven with an N₂-atmosphere. Microwave Plasma-Atomic Emission Spectroscopy (MP-AES) was used to determine the concentration of P and trace elements in the resulting solid char fraction. A combination of chemical fractionation (step-by-step leaching) of the DSS and thermodynamic equilibrium calculations were utilized to estimate the availability of phosphorous and removal of heavy metals in the SSC fraction at different temperatures. The results from the thermodynamics calculation were in line with the measured chemical composition of the SSC. Furthermore, the energy contents of the SSC obtained at different temperatures were measured. The pyrolysis evaluation results indicate that phosphorous was enriched in the char, while lead, zinc, and cadmium were significantly removed.